Should be a breaker in the power distribution box under hood
The circuit breaker is sized to the full load amps of the motor times 250%.
The breaker should be sized to 250% of the motor's full load amperage.
wiper motor on lincoln towncar 02
The selection of overload protection for motors is taken from a table in the electrical code book. It is based on the full load current rating of the motor.
The motor relay circuit breaker may be found on the driver's side of the vehicle, on or near the fender apron. There is a cable that runs from it to the battery.
Hey Maria==I don't think it has a relay. It should have a fuse and I thiink it has a circuit breaker in the motor. Check ALL of the fuses.Good luck Joe
Tripping is caused by excessive current, which is usually the result of a fault in cable or equipment. The circuit breaker is there for safety and it trips to prevent a possible fire starting.
The head lights and windshield wipers are protected by a circuit breaker (no fuse required) Sorry I have know idea where the circuit breaker is, never looked for it. It might be that you're wiper motor is bad. I have never herd of a breaker going bad. To test it run a hot right from you're battery to the input on the wiper motor. It maybe the switch I have had them go bad. You can't just put a toggle switch on it because it is a two speed motor it will not work.
how can you change a winshield motor for a 1992 Lincoln continental
16A
When a motor starts the circuit breaker sees an almost dead short. Until the motor starts generating a back EMF , which opposes the current flow when rotation starts, the current is high. If the breaker is sized to the motors full load amperage, each time the motor is started, the breaker will trip.
if the the motor is good you need to check the circuit breaker because the circuit breaker might be the problem. window doesnt go bad my dude the motor goes bad check it again