Top Answer
User Avatar
Wiki User
Answered 2008-11-23 19:15:48

it realies on the ABS cable front offside to work you will probably find that the cable has rubbed against the wheel and worn the cable through, i assume you have an ABS light on the dash board also Cheers Carl mrcapage" let me know

User Avatar

Your Answer

Related Questions

In the fascia fuse box, it is fuse number 20.

Difficult to work on and lots of garages wouldn't touch mine which is a Rover 75 V6 auto. I got a garage to carry out repair for about

How do i time rover 75 v6 engine/

Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180 Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180

in my opinion yes, i got my 75 rover a while back and it still works perfectly

where is the parking buzzer located in the rover 75 .its somewere in the front but i cant find were as it has stoped working

The height of the 2006 Land-Rover Range-Rover is 6 ft. 3 in. (75 in.).

you can find the sump plug in rover spares department.

you have to take to a rover dealer to put out the service light

i have a rover 75, 1.8. it has about 26,000 miles on clock. when does my timing belt need changing

Under the glove box. There is a drop down panel under the glove box held in place by two slotted retaining clips, twist these until panel drops then you can access fuse box.

under the rear seat on the drivers side on a v6 75

There are extensive guides on the Rover Owners Club forums. Google it!

The starter motor is at the rear of the engine.

Rover 75's can be fitted with Subaru alloys. Mabe others too. Would be good to find out.

It is at the front side of engine next to the trainsmission

$40 pounds. I had an EnVision textbook and this is one of the problems.Here is how you work it out: 75-35=40 40 pounds is five more pounds then 35.Read this untill you get or ask a adult to help.Please give it a thumbs up!

No need to take it out. You can just unplug it or find and remove the correct fuse. Look for FrenchMike - rover forum - and send the webasto pcb to him for repair. Its simple to remove the pcb.

Bring all keys and FOBs to dealership.

Its in the plenum camber. The most idiotic place on the car.

To bleed the clutch of a Rover 75, first remove the interior panels on the steering column. Second, remove the master cylinder and use a syringe to inject the fluid into the system and repeat 4 times to bleed the clutch.

May be a loose connection or an open resistor? maybe a loose fuse in the fuse holder? Bad fan switch?

No, take a look under steering wheel. No OBDII port