Any parts house can get you an adapter, Mr Gasket, tansAdapt, lot of mfg's.
Go to Summit Racing or P.A.W. on line.
No body make one for the caddy. You need to make a adapter plate for the manifold so you can bolt on carburetor.
ANY year that has a carburetor intake manifold available to install on the block/heads.
first you need to see if u can put a manual pump and a rod if so just put a carburetor intake on your motor and a vac disturber on it
No it won't be an easy swap. You have to take into account, manifold design, stud placment, fuel pressure, jet sizing etc etc so not an easy job.
yes. need to buy / mod the intake manifold for the new carb. low pressure fuel pump. and carb. and the distributor iia. that's all.
To convert an HP PSC 500 printer to a laptop, you need an adapter cable to convert the parallel port to USB.
Unfortunately, there is no known adapter that you can use to convert hdmi to dvi at the moment, but if you search best buy and staple, hopefully they will have some in stock.
Change intake manifolds to a manifold that accepts a carburetor. That's really all you need to do. I'd recommend against it though, because EFI is a LOT more efficient than a carburetor is. HP will likely go down while fuel consumption and emissions will likely go up. Now it will work just fine because there is very little difference internally between an engine that uses a carburetor and an engine that is fuel injected.
No adapter is needed, 110 and 115 volt are interchangeable.
You'll need an adapter. Contact one of the adapter manufacturers such as Advanced Adapters or similar.
Yes, there is an adapter that lets you use the controller for the PS2 with a PS3, it cost around $6.99.
are you tring to convert a car from coil packs to a distributored motor