answersLogoWhite

0


Best Answer
Replace the FilterImmediately replace the filter, and top the fluid level off. It may be defective or the wrong kind. Replace it with an OEM AC/Delco filter to be sure you have the correct filter. AC/Delco filters are very highly rated filters I recommend you use them on your Chevy.

Better answer-Change the oil to synthetic oil! The knock you are hearing is the piston skirts slapping the sleeve due to dry start! Mine did the same thing with conventional oil!

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Just had an oil changed and now the engine knocks at start up on 2001 Silverado?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does your 350 Chevy engine knock when cold start?

Your engine knocks when you cold start it because the motor oil is not viscous enough to lubricate crank bearings, cylinders, etc. warm it up first, engine will last alot longer


2000 Chevy silverado fuel filter was plugged changed now engine will start and run for about 30 seconds the die Can re-start 2 or 3 with same thing then will not start did you fry fuel pump with clog?

check fuel pump it could have come loose if not its bad replace


Why is a 2000 silverado 5.3 Vortec hard to start and the passenger side of the engine misses when it is started?

A 2000 Silverado 5.3 Vortec that is hard to start and misses on one side of the engine might have a problem with the coil pack or the spark plugs. It could also mean that the block is cracked if the engine is prone to overheating.


What are the signs that a Honda engine needs a P1457 check?

There are many different signs that will tell you that your Honda P1457 will need to be checked. Some of the more common are when the engine knocks and you start losing power.


On your 2003 1500hd silverado when you turn on the key before you start the engine the oil needle pegs to 80 and says there even after you start the engine Is the oil sensor bad?

Most likely a bad oil sending unit


How do you reset engine oil life in a 2005 Chevy Silverado?

Turn the key on then push the gas pedal to the floor 3 times. Then turn key off and then start engine.


When did they start making a 350 engine with a 4 bolt main?

1969... When they changed to the large journal crankshaft and engine block.


What would cause 99 Silverado truck not to start 1-2 times out of every 50 attempts then will start after 10mins I have changed the fuel filter and pump still seems to be straved for fuel any ideas?

Had a 93 Silverado that did the same thing. Had the electronic module replaced and all was well.


Your 1998 Silverado cranksbut will not start Is the fuel pump a good first place to start the troubleshooting Thanks?

check all fuses. there are 2 fuses that can prevent engine from firing if they are blown


Why does your 03 silverado lurch when you start it?

If your 2003 Silverado is lurching or jerking when you start it the most common issue is the fuel pump.


How do you reset the change oil light on a 2002 silverado?

Turn key on ,do not start, push gas pedal all the way to the floor 3 times, turn key off and then start engine.


You have your truck timed an it will not start still what are you doing wrong I have an 85 shevy silverado pickup?

If an engine has proper compression, fuel/air delivered in the right ratio and the ignition spark is delivered at the right time when the engine is turned by the starter, the engine HAS to run... no choice. Go back to basics. If you've worked on something recently and the engine ran BEFORE you worked on it, be suspicious of what has changed. It could be as simple as connecting the plug wires wrong.