answersLogoWhite

0


Best Answer

sorry to hear your problem .. i had similar problems .. try changing your front stabilizer's bush or change the whole bar ..

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Land cruiser LJ70 steering shakes when hitting pothole and driving on uneven roads?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Why would tires often need aligned?

Technically speaking the tires do not require alignment. It is the wheels and their axles that are aligned. The reason is that the attachment points for the axles are constantly moving and incur wear. In addition, the axle's supports can be bent by the vehicle hitting a pothole or striking a curb. The resulting misalignment causes the wheels and tires to not track properly (all point in the same direction). This causes the tire to scuff as it travels over the road. This scuffing wears out the tire prematurely and increases the misalignment. So the simple answer as to why wheels/tires should be aligned is to save the tires from being worn out before their time.


Will not go into drive or reverse and there is nothing wrong with your transmission?

If you know there is nothing wrong with the transmission, it is either the shifter handle not releasing completely, the linkage or cable to the transmission depending on which you have, or where they connect to the transmission. Did anything happen shortly before this started? Impact, any work in the engine compartment, hit a large pothole? Year, make and model of the car might be a factor in finding an answer.


2003 Ford Focus won't start?

the most common cause by far is the coil pack, its easy to change and a fairly cheap component - its certainly worth a try if the management light isn't on. if you want to be sure have the ecu fault code read as other possible causes are cam and crank shaft sensors. good luck.


Why does the water stored in mud pot remain cool?

Clay itself is a mixture of water and mud i.e., what we mould to make a pot. After that the wet clay pot is heated so that all the moisture in the wet clay is taken out completely. But who is going to fill the place of the moisture?? Nothing. So that whole material is purely porous with a very fine holes all over. Now when u pour water of any temperature more than the room temperature into the pot.. The water first spreads itself on to the walls of the pot. Due to the internal pressure of water, the water is forced to contact to the pot inner walls.(Don't get confused. This happens with any fluid or material, generally for solids its called as angle of repose, but for fluids, the angle of repose is 180 deg, i.e., horizontal force in all directions). So the water molecules starts filling the air gaps of the pot. In this condition, due to the very fine holes, the water molecules loose their contact and forms in to separate groups of water particles. Since the water volume is very less, it tends to go away from the pothole, and for that is has to be converted in to vapor state. But the temperature of the water is not enough to change its state from liquid to gaseous. So remember that the water is still in contact with the pot, so the heat is taken from the pot shell, thus reaches its latent heat and changes it state from liquid to gaseous. This is why the pot first cools rather to the water inside. In addition, this is a pure Heat and Mass Transfer subject. This is how the pot shell takes out the heat of the water and the imprisoned water molecules in the pot shell take that heat out and becomes vapor. If you can observe a pot with water for a while, check for the following points., 1) The Whole Pot Gets Wet in outside till the level of water. 2) If you can feel the water getting cooled after an observation of 30 mins., then check for the water level in the pot. (It surely goes down and where does that water go ??) 3) Check the Pot Shell inner face temperature and water temperature, and find out which is lesser. :in an easier way..we can say that the mud pot or clay pot is a poor conductor


Words that starts with p?

pop, popcorn, popular, pool, paste, party, parent, paragraph, power point, power, point, poop, pictures, programs, panel, printer, precious, pretty, property, properties, proper, price, priceless, print, printing, play, playing, popcicle, perfect, penis, pussy, porn,papas, picked, peck, pickeled,papayas, papapapapas

Related questions

What causes a shifted belt on a tire?

Striking a curb, hitting a pothole at higher speeds. Defective Tire. Striking a curb, hitting a pothole at higher speeds.


What causes a tie rod to bend?

There are many causes for a tie rod on a vehicle to bend. This can occur due to hitting a pothole while driving or a curb.


Can hitting a pothole can head gaskets damage?

No, impossible. the head gasket cannot be affected by a pothole unless the engine fell out and the rest of the car drove over it.


What can cause bent tie rod ends?

Hitting a serious pothole or slamming a curb will bend it.


Could hitting a pothole cause electrical damage to your car?

It could loosen wires. Yes.


What would cause the fuelnemergency cutoff to engage on a 1996 ford explorer 4.0?

A collision or hitting a bad pothole


What is the cause of a grinding noise that appears in the front end of a vehicle after hitting a pothole?

Most likely a bad axle


Why does my car pulls to the left side of the road even when I hold the steering wheel straight and to drive it in a straight line I have to turn and hold steering a little bit towards right?

Tyre pressure low. Hitting the kerbor a pothole has misaligned the wheel. The wheel has a weak suspension spring or shock absorber. Brake binding. Excessive play in a suspension or steering joint causing misalignment of the wheels.


Who is at fault if you hit a pothole?

It is your fault for hitting an object that does not move. The owner of the road can not be held at fault unless he or she created it for the purpose of damaging a car.


When do the waves bounce?

Like when your mom is driving along, and hits a pothole. Ride the waves while they last.


How do you use a thump word in a sentence?

A thump word can be used to add emphasis or intensity to the sentence. For example, "The car came to a sudden thump as it hit the pothole," where "thump" emphasizes the abruptness of the car hitting the pothole.


What is the most common problem from hitting a giant pothole?

Throwing your alignment out or busting a hole in the oil pan or losing a hubcap or blowing out a tire or bending a rim.