The wires are Gray (from the PCM), and Gray-Red, (from fuse-box)
The intake air temperature sensor is connected to the mass airflow sensor as one unit, it's at the beginning of the air intake tube just after the air cleaner. The sensor with six wires running out of it
On a 2000 Ford Explorer : YES ( the intake air temperature sensor / air charge temperature sensor should be in the rear side of the big rubber engine air intake tube , located between the engine air filter and the throttle body )
Look for a wiring harness and connector, that connects to the air intake tube. That is where your intake air temperature sensor is located
On my 1995 Ford Explorer - 4.0 L - OHV - V6 , the intake air temperature sensor is in the big rubber air intake tube , facing to the rear , near the throttle body . A 1996 - V6 - should be the same
Assuming it has the 5.0 engine, the (IAT) Intake Air Temperature Sensor is located in the air intake snorkel between the air filter box and the throttle body.
The intake air temperature sensor can be found on the top of the air intake manifold. The temperature sensor should be labeled as such.
The IAT (Intake Air Temperature) Sensor is a Two (2) Wire sensor located close to the intake.
The air intake temperature sensor can be found on the top of your manifold intake. The sensor will be right in the middle of the intake manifold.
On your 1994 Ford Explorer , I believe the intake air temperature sensor is mounted in the side of your upper intake manifold , not too far from the idle air control valve , as you look along the side of the upper intake manifold towards the firewall (Helpfull)
The intake air temperature sensor is located on top of the intake. In a 1990 Toyota Camry the air temp sensor assures the ECU the engine is running at optimal temperature.
Code P0113 indicates a intake air temperature sensor circuit high output. Check the connection to the intake air temperature sensor and if that is fine consider replacing the intake air temperature sensor.
an intake air temperature sensor is a sensor that is used to measure the temperature of the air that flows through your intake manifold into your engine.it is usually posisioned on the intake filter housing.