answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2008-09-04 07:30:48

the brown wire to the left side try alldatadiy.com for any wire shcamatics and pin outs

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Yes ,there are 3 of them coming right off the battery.


It should be on a wire coming off the battery. Not like a factory fuse. There should also be a relay mounted on your firewall passenger side.


If it is coming from the radiator or the hoses this would mean your antifreeze is boiling in the lines. I would recommend first changing the thermostat and bleeding the air from the rad lines.


I have a 95 Pathfinder and had a similar issue. The engine would cut out when coming to a stop or making a turn but was fine when giving it gas. I had a fuel system flush done (but not a new fuel filter) and it has been fine since.


The O2 sensor should be located just upstream from the catalytic converter in the exhaust stream. look for a metal tube with 2 wires coming out of it screwed into the top of the pipe.


The 2010 Nissan Murano should be coming out in the Spring of 2009 like around March or April. There will be a ragtop/convertible coming out later that year as well.


It is located between the air filter and the throttle body. it is the hard plastic tube with a square flat box attached to the bottom with a wire harness coming out of it.


should be right in front of the battery. The two hard lines on the plenum and one connecting it to the egr valve. Also there should be a black connector coming off your EFI harness attached to it


It's on the left side of the intake plenum looking at the cars front. It's screwed sideways on the left side of the intake plenum with a hose coming right off of it. It's not visible unless you remove the upper and lower plenum.


There is not a Nissan dealer that is located in Gamebridge Ontario. There is not a confirmation, at this time, from Nissan, that there will be a dealer in this city.


i work for Nissan deallership. i have seen sentras and altimas coming with 230,000mi and more! Its amazing!



Pipe coming out of the fuel tank



If you are installing the engine in an exact model that the engine is coming out of, the harness should not be needed. If there are any changes in model, sensors or anything else then the harnesses will not be interchangeable.


The best answer I found for my 2002 Astro was to keep the trailer harness inside the van until needed, then simply open the door, bring out the harness, and close the doors with the harness on the floor of the van, coming out between and under the dutch doors. The rubber gaskets around the doors allow the doors to close on the harness without putting a kink in it, even. This protects the harness from weather when not in use.



air can only enter a fuel system in a suction situation so check fuel lines between fuel pump and fuel tank for cracking or holes, i am guessing that you have a rail mounted fuel pump since a tank mounted pump hardly ever has this problem if it is the latter then replace the in tank fuel pump unit.


Many things can be found on the Nissan website. Some of these things include information on purchasing a new or used car. They also have information on newer models coming out and special deals on Nissan cars.


it right under the dist. cap .... it has a wire harness with 2 wires coming out of it


It's coming from the Time to Rest alert


look for antifreeze coming out of the radiator as the engine warms up after a cold start.


They are a dealer item and can be found online, maybe Ebay, also at a salvage yard. But expect to pay $1200 for a brand new harness. In 1999 they started coming without/EGR.


In my case on a 2001 Dodge Intrepid, there were two bare wires in the wiring harness coming into the trunk lid. It was in the area where the wiring harness is clamped to the trunk (left side) just at the lip of the trunk recess. I wiggled that harness and got the dash trunk light to flash on & off. Peeling back the wiring harness cover at that point revealed the bare wires. Taped them off individually, and then retaping wiring harness at that point solved my problem.


should eather be at the top in to engine or on bottom hose coming from engine



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.