it starts but the oil light stay on
The emergency signal flasher module can be found below the dashboard, on the drivers side of the engine compartment. The emergency signal flasher module simply plugs in and out.
What indicator are you talking about? Turn signal, emergency flasher, check engine light, abs light, oil light, temp light, alt light, etc. We can't read your mind.
You may have a "ground loop" problem on the left turn signal. Check the ground wire at the front and rear signal bulbs.
Indicator is Brit Speak for turn signal. If you are receiving the message on the dashboard display, it will tell you if your what side (left or right) you are having the problem with.
If you are getting an indicator of a burned out light, but don't see a burned out light, it must be a turn signal light. On a Mercedes, you'll actually get a "burned out light" indicator if the turn signal is not working.
You have a turn signal light-bulb out .
sounds like a wiring problem
Sounds like the turn signal indicator lights.Sounds like the turn signal indicator lights.
The turn signal indicator relay switch can be found below the dashboard on the drivers side. The signal indicator relay switch should be labeled as such.
my 2000 Chevy Van's left turn signal is clicking erratically. What should I do? Check your indicator light bulbs as one may be out. There could be an earthing problem if not the bulb.
Just had the same question and found the answer... According to my manual for a Mercedes-Benz 560SL 1986 It is the Exterior light failure indicator lamp. "The light failure indicator comes on with the key in steering lock posion2 and will go out when the engine starts. If it comes on with the engine running, it indicates a a light failure. If an exterior light fails, the indicator will come on only when that light is switched on. If a brake or turn signal lights fails, the light failure indicator will come on when applying the brake or actuating the turn signal and stay on until the engine is turned off. CAUTION! If additional lighting equiment is installed (auxiliary headlamps ect.) to avoid damage to the failure indicator system, be certain to connect into the fuse before the failure indicator monitor unit.
SOS