A diagram of timingÊmarks for the Mazda MX6 is available in the Haynes Repair Manual for that make and model. The manuals are available at most auto parts stores.
This is done the same as the 1995 Mazda MX6. The answer is posted.
On a 1994 Mazda MX-6 : Both the 2.0 liter four cylinder engine and the 2.5 liter V6 engine have a timing BELT
mx6 got no moonroof - only a sunroof and YES its interchangeable
there should be timing marks on the pully for the drive belt. If not take out the number 1 spark plug and put a crew driver in the hole. Bump the motor until the piston is top dead center. Then put your belt on and put your spark plug back and your good.
9 degrees btdc with test lead mear wipermotor earthed
If your asking this question than you shouldn't be performing this job yourself<
1,2,3,4,5,6
The answer to your question is the same for a 2.0 or 2.5... replace the timing belt and all of the pullies as well as the tensioner (spring-loaded on the 2.0L and hydraulic piston on the 2.5L).Go to probetalk.com and look for the how-to in the appropriate section. (probe and mx6 are built on the same chassis and drivetrain)
broken air intake after the air filter and the mass air flow censer. connects to throttle.
If you have the standard 1995 Mazda MX6 then it came OE with P195/65R14... I hope this has helped. COO of TireTyre.com
on the driver side you have to remove the intake hose, follow the fuel line going to the fuel rail and you'll find it.