0
My engine light says it is misfiring and i have already replaced the spark plugs the wire set and the ignition coil How much does it generally cost to clean the intake manifold?
Wiki User
∙ 16y ago
maybe you have some bad gas try a can of dry gas
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
2001 Taurus is misfiring Mechanic says the coil pack needs to be replaced - does this sound right?
Bad ignition coil will cause engine to sputter and hesitate on acceleration.
What causes a 1998 Renault Clio 1.4 to run sluggishly after the ignition coil and cylinders two and three and the exhaust manifold were replaced because it was misfiring?
I have the same problem I dont know what to do My Renault Clio 1.4 is doing this same problem and I am wondering what to do when u start the car it starts to vibrate Please help
Why is your trailblazer misfiring after you replaced the spark plugs?
Bad plug or something is misassembled.
What else could be wrong if 2 cylinders are misfiring after getting water into the motor through the intake after the spark plugs and ignition coils have been replaced and it is still misfiring?
I really hate to be the one to tell you the bad news but it is possible that you have bent some valves. Take the spark plugs out of the missing cylinders and run a compression check on those two.
Why would your ride-on lawnmower backfire?
If it backfires while you are driving, the intake manifold bolts may be loose or the gasket may need to be replaced. If it backfires when you turn off the ignition, the fuel mixture is a little on the rich side.
When Lincoln Town Cars intake manifold has been replaced now it wont even crank over battery getting 12 volts any ideas was running fine before?
The reason a Lincoln Town Car might not start after the intake manifold was replaced could be that the MAP (Manifold Absolute Pressure) sensor was not installed properly after the manifold was replaced. The computer might also need to be reset.
What would cause a rough idle when in a 1998 Oldsmobile intrique with the 3800 series II gets worse in cold weather?
Could be a bad ignition coil, a bad ignition module, or bad gaskets on the manifold(s). I'm assuming you've already replaced the plugs and wires or they're fairly new.
I replaced the coil wire in my 1994 dodge ram 2500 after it touched the exhaust manifold and melted but i now have no spark?
sounds like the coil wire melting to the exhaust caused a short circuit in the ignition system, check all your ignition fuses (at the fuse box most likely under the hood) and go from there.
How do you repair a cracked manifold on my suburban?
It must be REPLACED with another 1.
How do you replace the ignition timing on a 1987 Dodge Ram 350?
the ignition timing does not get replaced on 87 dodge.
Why wouldn't key turn in the ignition PT Cruiser?
The ignition is shot - just replaced mine $315.00.
You have replaced your exhaust system with a new one up to the exhaust manifold the exhaust manifold looks fine but you still get loud engine noise inside the car?
have you checked to see if there is any broken bolt on the manifold, or worped manifold, burnt manifold gasket
