I detail headlights at used car dealerships and what I do is drill a TINY hole on the lower edge of the headlight to let the water out. The heat from the light bulb will eventually dry it out. To clean the outside of the lens I use a product called CrystaLenz, this stuff really works great. Check out their website www.CrystaLenz.com for more information. ==Answer == You can also dry the lens out by talking the bulb and socket off the back and inserting a dry clean rag or towel through the opening and clearing the lens from the inside with a long object like a wooden stick. Once a hole is drilled, moisture can re-enter of course if not plugged with something like silicone. I have had the same problem.
To clean the inside headlight lens on a ford ranger just simply remove the cap and clean.
Throw rice on it about 2 gallons 5 times
detach the bulbs and remove the clips behind the headlight assembly
You cannot remove the moisture for the long term as the sealed beam seal has failed and moisture will continue to appear later. Usually a heat gun could be used to heat up the glass, careful not to melt any nearby plastic parts. Best bet is to replace the headlight.
The AC runs to remove moisture from the air inside your vehicle. Moisture causes the fog inside of your windows. The ac runs to remove the moisture and the heater runs to heat the air.
You can try removing the headlight bulbs and use a blow dryer to blow in the hole where the bulb was to remove the moisture. More than likely it will just come back as you either have a leak or the seals for the bulbs is not sealing properly. The car is 15 years old so it may be time to buy some new headlight assemblies especially if they are cloudy.
Raise the hood. Remove the whole headlight unit. Nuts are reachable from inside. Not too difficult pc
If you have composite headlights, you can remove the bulb, remove the headlight assembly, use some headlight lens cleaner, rinse it out, and let it dry. If you have sealed beam headlights, you can only change out the assembly or clean the lenses only on the outside.
remove the moisture from inside the walls and floor.
yes
To remove the headlight housing (question is kind of vague, I have to assume this is what is being asked): Open hood & remove center grill. There are two bolts on each headlight housing on the inside, you will find them just behind where the grill was. Remove the two on the headlight housing you are trying to remove. Remove side marker light on the side you are removing the headlight from. You will find two nuts holding the headlight housing to the frame, remove them. Housing is now unbolted and can be slid out/off of the car.
you need to remove grille first before you can remove headlights and then there are four bolts to remove headlights it takes about one hour to do this job and have fun.