There is no question here!
There are two bolts that hold the tail lights in place. First, open your tailgate. If you have a bedliner, the two screws are behind it. If you have a bed extender, the bolts that secure the taillight are the same bolts that secure the brackets for the bed extender. Refer to your owners manual, page 8-35. Good luck.
A 2002 Nissan Frontier bed will not fit a 2000 Nissan frontier.
I need to find a tire carrier for a 2004 nissan frontier 4x4 under the bed
no its a different body style
While different models will have somewhat different instructions, the most common way is to add brackets to the inside of the truck bed that the extender will fit into. Once this has been put in place properly, the truck extender should slid out when in use, and slide into the truck bed, behind the tailgate, when not in use.
There was a recall on the 2000 Nissan Frontier because the bulbs would fall out from vibration and driving. The dealer modifies the bulb holders within minutes, free of charge. On 2000 - 2007 year model Frontiers, there are two phillips-headed bolts on each inside corner of the truck bed, behind the tailgate latches, that may be used to attach the brackets for the optional bed extender. If you have a bed liner installed, you will need to pull the corner of the liner back to expose the bolts. An illustration is available on page 271 of the 2006 model user manual, which is available in the "Related Links" section of this answer. User manuals are also provided online for 2005 and 2007 models at the provided links.
You are going to have a hard time finding a cargo liner for a Nissan Frontier. The cargo liners are only for station wagons, SUVs and Crossovers. You might mean a bed liner.
Go to the in side of the bed and the are two screws and the it pop off
If you have a bedliner, the two #1 Phillips screws are behind it. If you have a bed extender, the bolts that hold in the tails are the same for the brackets for the bed extender. This also applies to newer Frontiers as well. Mine is a 2004. The bedliner concealed the 2 screws. After removing the 2 screws the tail light assembly can be pulled slightly to the rear. There are 2 plastic plugs that are holding it in at this point. Grasp the assembly at the top and bottom and pull firmly to the rear. Turn the bulb assembly counter clockwise to remove. The bulb will pull straight out. I suspect that as the vehicle gets older this plastic plug system will break. The female parts can be replaced as they screwed into the body. To reassemble a sharp rap with the heel of the hand will reseat the plugs
If you have a bedliner, the two #1 Phillips screws are behind it. If you have a bed extender, the bolts that hold in the tails are the same for the brackets for the bed extender. This also applies to newer Frontiers as well. Mine is a 2004. The bedliner concealed the 2 screws. After removing the 2 screws the tail light assembly can be pulled slightly to the rear. There are 2 plastic plugs that are holding it in at this point. Grasp the assembly at the top and bottom and pull firmly to the rear. Turn the bulb assembly counter clockwise to remove. The bulb will pull straight out. I suspect that as the vehicle gets older this plastic plug system will break. The female parts can be replaced as they screwed into the body. To reassemble a sharp rap with the heel of the hand will reseat the plugs
there are 2 bolts on the side of your bed inside. its a 10mm bolt, unscrew and then the light comes out.
Under vehicle, passenger side, below bed area mounted in fuel line.