No reverse gear on manual transmission s-10?
An s-10 transmission with no reverse most likely has an internal problem. The shifter fork or a gear issue can cause no transmission reverse.
If third gear on a 1990 4.3 Chevy S10 4x4 5-speed grinds and 2nd gear is rough is it the clutch or transmission?
What is the function of the electrical connection to the transmission on a 2003 Chevrolet S10 Pickup?
Bad synchronizer. Answer I have an '86 S10. When it will not go into reverse or grinds going into reverse, it helps to put it in 2nd then reverse. Answer Most manual transmissions do not have a sychronized reverse gear. When you try to go into reverse from neutral, the transmission countershaft (which is linked to the pilot shaft) is still turning. The main shaft (which is linked to the tailshaft) is not turning. Therefore…
There is a plug on the side of the tranny. take it out. If fluid runs out, put the plug back in the hole and get on with life. If no fluid runs out, check your manual for what transmission fluid to use. Fill it till it runs out at the plug a bit. Be sure to use the transmission fluid recommended for Chevy S10 5 speed manual transmissions.
because reverse gear sprocket is about to break off and when it does you won't have reverse until you buy a new/used transmission. had same problem on 93 Jimmy SUV for over a year but just tried to avoid using reverse on any incline or hill and it hung on. I think I caused it by hauling a boat and backing up a hill into the driveway instead of backing down the hill into driveway…