It could be A few things, I would start with the distributor cap and rotor, The rotor can get A pin-hole in it and let it create A shorted firing route.,,, If this is good, Then crank the engine with the dist. cap removed, See if the rotor is turning, If not you have a broken timing chain or cam. ,, If it turns, Test the igition modul. If this does not help, You can contact me through 'My personal message board'. Good luck,.
98 Oldsmobile 3.8 cuts off will driving wait a few min's an it cranks back up
check your timing belt
If your 1999 Ford Mustang cranks but won't turnover you may have a problem with the starter, the solenoid, or the alternator.
If it just cranks and cranks and cranks then it's likely fuel pump. If it died and it won't turn over anymore, likely alternator.
No you were driving and it quit.and if it cranks it is turning over. check for spark at the spark plugs and also for fuel pressure at the injector rail.
it sounds like the oxygen sensor is going bad. it is located in the exhaust and you will find a wire that should plug into it. it should be just under the exhaust manifold.
I was driving on the highway and the car just stalled and wouldn't restart. Originally it showed a code for cam position sensor. I changed the cam pos sensor. It still wont start. When I try to start it it cranks much faster than normal. Now it shows a code for a MAP sensor. I changed that...nothing. Any ideas.
last week it ran good allday then it ran out of gas so this week i filled it up it fired up then stalled and it wont start again whats going on
it is easier to pedal with longer cranks because you have more leverage but it is not necessarily better to have really long cranks.
On one had you say it cranks and then you say it won't turn over. Which is it? If it cranks, then that means it IS turning over but just won't start. If it won't crank then it is NOT turning over. We need to know which it is to determine what may be causing this. Repost this with a better description of your situation
TCC Solenoid.
do you mean it cranks, but will not start?