0
On 1994 Chevrolet Silverado 1500 5.7L 2WD where do you locate the ignition timing bypass connector?
Wiki User
∙ 17y ago
look under carpet on pass side under dash single wire horizontally
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where do you locate the electronic spark timing bypass connector on a 94 Chevy silverado 1500 5.7L?
your truck does not have a bypass connector
On 1994 Chevrolet Silverado 1500 5.7l 4 wd where do you locate the ignition timing bypass connector?
you're looking for a tan wire with a black stripe. first look under the dash behind the fuse panel, in the far top corner. then check under the relay cover and near the distributor.
What is engine trouble code 42 for a 95 Chevy silverado?
Ignition bypass circuit error
Where do you find electronic spark timing bypass connector on a 1997 Chevy silverado 1500 5.7l?
That year did not have one because the timing is computer controlled and can be only adjusted with a Engine SCANNER.
How do you adjust the ignition timing on a 1992 Pontiac Firebird?
disconnect the tan wire connector on the passenger side wiring harness , that puts it in bypass mode, unlock dist. bolt and adjust timing. when set reconnect wiring connector.
How do you bypass a neutral safety switch on a 2004 Chevy silverado 1500?
How do u bypass the neutral safety switch in a 2002 chevy silverado 1500
How do you bypass the ignition module to crank a 2000 Chevy blazer 4.3?
It will not run if you bypass the ignition module (no spark).
How do you remove the speed governor on a 1997 Chevrolet Silverado 1500?
There is a simple way to get past the governor, just as your going top speed hold in your round cruise control button and it will bypass the governor.
How do you get around the passlock on a 99 silverado?
you need a bypass directedelectronics.com
How do you bypass ignition switch on 2000 intrigue?
No
How do you bypass an ignition control module?
You Don't
When the switch button fails how do you bypass motorcycle ignition wire?
If you have broke your ignition switch or lost the key disconnect the ignition barrel from the white connector plug then pull off the the key hole then with a knife peel back the casing around the wires to bear metal and wrap them together and attach the ignition back and it should be like turning the key.
