answersLogoWhite

0


Best Answer

u need to have your coil packs checked

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: On a 1996 Lumina 3.1 is hard to run on humid and rainy days will run good in winter engine starts but backfire needs to run and set for 30 minutes all sensors changed?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where are the three oxygen sensors located on a 1996 Chevrolet Lumina 31?

where is the oxygen sensor located on a 1997 Chevrolet lumina


What would make a 1990 Chevrolet lumina run sluggish and backfire when decelerating?

It can mean that this engine is out of time. You may need to have it timed.


1993 Chevy Lumina have changed NUMEROUS sensors but still just cranks over and over and will not start Have changed fuel pump it HAS gas it HAS spark so why?

have you checked to see if the timing belt or chain is broken? have you checked cylinder compression? is the oil up to proper level?


Where is the oxygen sensor on a 92 Chevy Lumina?

Most oxygen sensors are either on the exaust headpipe just after the manifold or on the manifold. I don't know where it is exactly on the Lumina but that is where you should start looking.


1992 lumina apv 3.1 no spark changed distibtor coil relay the computer there are no crank no cam sensors timing is on what else could it be?

Bad coil? Bad distributor cap? If not HEI ignition-could be bad coil wire


How do you fix abs light 94 Chevy Lumina van?

Check at the wheels to make sure that the abs sensors have not become disconnected. The wiring or the sensors are the most likely causes.


How many oxygen sensors does a 1994 3.8l Chevy lumina van have?

2 ONE UNDER THE MANAFOLD AND IN FRONT OF THE CADALIC CONVERTER


Where is the crank sensor on a Chevy Lumina Z34?

what year? and what size engine? crank sensors are in different locations based on year and engine size.


Where is location of oxygen sensor on Chevy Lumina APV 3.8?

That vehicle has several O2 sensors and they are all threaded into the exhaust system at various points.


Abs light reset 92 Chevy lumina?

The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.


What are the locations of Oxygen censors in a 1992 Chevy lumina 3.1L?

All O2 sensors are located on the exhaust system. Start at the exhaust manifold and work your way backward.


Brake lights arent coming on changed bulbs and fuses and no results what else needs to be checked on a 98 Chevrolet lumina?

If the brake lights are not coming on in your car and you have changed the bulbs and the fuses with no results, you could also check the wiring in your '98 Chevrolet Lumina. The wires may be damaged or even broken.