0
Add your answer:
Earn +20 pts
Where is the oxygen sensor located on a 1998 Chevrolet Malibu?
All oxygen sensors are located in the exhaust system.
Where are the Oxygen Sensors located on a 2005 Chevrolet Impala?
They are located before and after the catalytic converters in the exhaust system.
Where is the oxygen sensor on a 2002 Chevrolet Malibu?
All oxygen sensors are located in the exhaust system either before or after the catalytic converter.
How many oxygen sensors on a 2005 Chevy astro?
There are approximately 2 oxygen sensors on a 2005 Chevrolet Astro van. The oxygen sensors can be purchased at stores such as NAPA.
Chevrolet Tahoe has two oxygen sensor how can you check tham?
2002 Chevrolet Tahoe has two oxygen sensors How do I check them ?
Where are the oxygen sensors located on a 1997 Chevrolet Pickup?
Depending on the exhaust system, there will be one before and one after each catalytic converter.
Where is the oxygen sensor switch located on a 1989 Chevrolet Caprice?
All Oxygen Sensors are located in the exhaust eitherbefore or after the catalytic converter. Your O2 sensor may not be defective as a vacuum leak can cause the code.
Where is the oxygen sensor on a 92 Chevy Lumina?
Most oxygen sensors are either on the exaust headpipe just after the manifold or on the manifold. I don't know where it is exactly on the Lumina but that is where you should start looking.
What are the locations of Oxygen censors in a 1992 Chevy lumina 3.1L?
All O2 sensors are located on the exhaust system. Start at the exhaust manifold and work your way backward.
Where is 92 cadillac sedan 4.9 oxygen sensors?
The oxygen sensors are located in the exhaust pipes.
Where are the Oxygen sensors located on a 1998 Chevrolet Silverado half ton truck?
All oxygen sensors are always screewed into the exhaust system/pipes, there will never be any after the muffler. There about 3 to 4 inches long with a electric wire connector pluged into them.
How do you change 1998 s10 oxygen sensors?
The oxygen sensors on a 1998 Chevrolet S10 are changed by disconnecting the lead wire and unscrewing them from the exhaust manifold. New sensors are then screwed into place and the wires reattached.
