Auto Parts and Repairs
Oldsmobile Alero
VW Jetta
Crankshaft Sensors

On a 98 Jetta GLX VR6 where is the camshaft positioning sensor located?

789

Top Answer
User Avatar
Wiki User
2008-03-23 17:05:16
2008-03-23 17:05:16

i just had that fixed on my 97 jetta trek ... it's located in the distributor, just buy a new distributor it's about $400 dollars tho.. unless u get a used 1 .. once u replace that it willl turn off your check engine light!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl

User Avatar

It is located in the distb. 4 inches under distributer behind the motor mount on 2.0 liter.

User Avatar

how to remplace position of oxigen sensor

User Avatar

The speed sensor in located in the front of the motor. You can find it near the transmission and the engine split line on the Jetta.

User Avatar

The speed sensor on a 98 Jetta is located near the brake setup. It is on the passenger wheel area mounted to a bracket.

User Avatar

it is also throwing a code for the camshaft position sensor. and yes i did have the timing checked

User Avatar

Weird location, But it's just behind Oil filter. Probably if you get ubder the car you should be able to see it.

User Avatar

YES THERE IS A SENSOR, IT IS LOCATED ON THE FRONT OF THE ENGINE WHERE THE TRANSMISSION AND BLOCK BOLT TOGETHER NEXT TO THE STARTER AND ALMOST UNDER THE OIL FILTER COOLER that's the CRANKSHAFT sensor, crankshaft and camshaft are not the same

User Avatar

Trouble code P0343 means: Camshaft Position Sensor A Circuit High Input (Bank 1 or single sensor)

User Avatar

2004 vw jetta 2.0 how do I find camshaft timing mark

User Avatar

A knock sensor sends a voltage signal to regulate ignition timing. In a Jetta, it is typically located under the air intake manifold.

User Avatar

The front crash sensor is located inside the airbag control module.

User Avatar

In side bell housing in the transmission.

User Avatar

right in front if the battery terminal on the transmission

User Avatar

its located on the oil filter housing....

User Avatar

The oxygen sensor on a 2004 Volkswagen Jetta is located in the engine area. It is usually encouraged to warm up the engine so as to ease the threads.

User Avatar

http://forums.vwvortex.com/zerothread?cmd=print&id=3977482

User Avatar

remove the polin filter cover and you will find the AIT sensor next to the polin filter

User Avatar

The MAF ( Mass Air flow) sensor is located right on the intake pipe. Can't miss it.

User Avatar

The mass airflow sensor, on Most VW Jetta Mark IV, is located on the air line that goes from the air filter to the intake.

User Avatar

The intake air temperature sensor is located just after the top of the intercooler. It will have color coded wires coming from it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.