Dodge Durango
Oldsmobile Alero
VW Jetta
Crankshaft Sensors

Where is located the camshaft sensor on a 1996 jetta?

323334

Top Answer
User Avatar
Wiki User
2006-01-29 01:08:44
2006-01-29 01:08:44

It is located in the distb. 4 inches under distributer behind the motor mount on 2.0 liter.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The sensor is located inside the distribuitor

User Avatar

The Camshaft Position Sensor is located behind the Power Steering Pump.

User Avatar

its located in the distributor.

User Avatar

1996 and later models-the camshaft position sensor is located on the back of the distributor, drivers side.the loss of the camshaft position sensor signal will not affect the driveability of the vehicle. whoops,that sensor is located in the distributor,the one on the back is the ignition module.

User Avatar

The 1996 BMW 328 camshaft position sensor is located on the front of the cylinder head. The camshaft position sensor should be labeled as such.

User Avatar

where is the camshaft position sensor laocated at on a 1996 ls 400 lexus

User Avatar

were is the camshaft position sensor (cmp) location on a 1996 caprice classic

User Avatar

It is located on the distributor under the cap and rotor.

User Avatar

It's inside the top part of the engine.

User Avatar

It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley

User Avatar

The Camshaft Position (CMP) sensor is located on the passenger side of the engine and is accessible after removing the right front tire-2.2L engine.

User Avatar

on the back of the engine . above the starter 10 mm bolt holds it in.

User Avatar

depends on the engine but it is usually on the top of the bellhousing of the tranny. the crank sensor gets a pickup signal from the flywheel.

User Avatar

The cam sensor is the "pick up plate" in the distributor, under the rotor.

User Avatar

It does not have one. It still has a distributor

User Avatar

It is located almost adjacent to the oil filter and right beside the transmission bellhousing. The plug is located beside knock sensor plug attached to the motor mount.

User Avatar

The Cam Sensor in a 1996 GMC Sonoma is located in the distributor under the rotor cap

User Avatar

the cranck sensor is on front of engine it reads the teeth on crank pulley.the cam sensor is on top of same side of engine.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.