A bad blower resistor will not make a vibrating noise by itself. Carefully remove the blower resistor (under the dash at the passenger side right foot area.) check to see that it is not hitting the fan. PS a bad blower resistor usually means that the blower will only operate at high speed. Usually a small fusible link on the resistor ceramic opens. Can be replaced with a small link of unmelted solder.
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.
The blower motor resistor is mounted next to the motor on the passengers side under the dash..............
change the blower motor resistor. done deal.
The 2001 Nissan Quest blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
i am looking for the location of a heater blower resiter on a 1996 Nissan Serena
You can find the 2004 Nissan Maxima blower motor relay switch beneath the passenger side dashboard. The blower motor relay switch will be behind the glove compartment.
The blower motor resistor on a 1993 Nissan Altima is behind the glove compartment on the passenger side of the vehicle. To access the blower motor resistor, the glove compartment can be removed by lowering the bottom as much as possible and removing it from the hinges.
One can replace blower motor resistor on 2003 Nissan altima by removing the old using spanners and replacing it with a new one.
It might be your resistor, does it work on 4 but not on 1,2,3? If so, you need a new blower motor resistor.
They are generally found close to the blower motor.
Check to see if you have 12 volts at the blower motor. If yes then the blower motor is bad. If no, then the resistor, relay, or fuse is bad.
Your blower switch sensor is out. Replace it!Then all the speeds will work