answersLogoWhite

0


Best Answer

crank sensor

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Plymouth breeze It dies when it gets to temp The trouble code is no crank reference at pcm?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What makes a 96 Plymouth breeze crank over but wont start?

Check for fuel Check for spark


Why would a 2000 Plymouth breeze crank and not turn over?

Have you checked for fuel and spark? Camshaft sensor and or crank sensor will cause that problem as well!


1997 Plymouth breeze randomly stalls and starts?

Start by checking the 1997 Plymouth Breeze for proper fuel pressure. Also check for any loose connections at the crank position sensor or the coil packs. Any of these could cause the stalling problem.


My 97 Plymouth breeze stops every know and then. But will re-crank. And my mechanic doesn't know what is wrong with it. He hooked it up to the mechine and it showed nothing does anyone know why?

crank position sensor


Crank sensor for 1996 Plymouth breeze?

The crank sensor sends a signal to control the spark timing to the engine. If the sensor goes bad the engine may run rough or not run at all.


How do you change a rear crank oil seal in a 1997 Plymouth Breeze 2.4 liter motor?

The transmission would have to be removed, which is a really big job


How do you remove the window crank on a 1998 Plymouth breeze?

It is held in place by a horseshoe shaped clip. the clip is removed by reaching behind the handle with a small pick and pulling the clip out.


My 98 Plymouth breeze won't start. Will make sound like it is going to crank but wont?

Check the engine ground before replacing parts. I have a 97 Plymouth Breeze that would not turn over, but the lights and radio worked. After replacing 4 parts (starter/solenoid, ignition switch, crank case sensor and safety switch), it turned out that the engine was not grounded properly. Once the ground was reattached correctly, car started.


What does a Code 11 mean on a Plymouth Grand Voyager SE 3.3L engine?

MIL Code 11 = No crank reference signal detected during engine cranking. Good luck!


1996 Plymouth breeze cam sensor will it cause the car to start and run until it gets warm and then stall and not start again until it cools off?

yes, that could be a cause. Along with fuel pump, crank sensor,....


Where is a 1992 Plymouth acclaim crank sensor?

No crank sensor. Only has the distributor pick up plate.


Where is the Crank sensor on 1991 Plymouth Voyager?

there isn't one