Want this question answered?
Could be you have a temp sensor for the ECM and a temp sender for the gauge. The gauge sender generally has one wire attached to it. The temp sensor generally has two wires attached to it. Perhaps you changed the wrong one.
Replace sending unit
why doesn't my rpm gauge and temp gauge, fuel gauge not work
195 to 210 is normal
should be 195 to 210 normal operating temp
1996 prelude temperature gauge reads low temp
temp gauge is stuck on hot
Answerheater core will most likely be the problem Answerheater core will most likely be the problem Had same problem. Is your temp gauge reading normal? If temp gauge is reading low after driving awhile, may be the thermostat stuck open. If so, easier fix than heater coil.
only 3 reasons a temp gauge wont work the temp sender is bad the gauge is bad or the wire from temp sender to gauge is broken
It all depends on the rating of your thermostat which is usually 180 to 195 degrees if using a aftermarket temperature gauge and headers the temp. gauge reading will be higher than normal because of the excessive heat from the headers.
its a transistor located behind the cluster panel.usually cost 45 dollars from nissan......symptons are usually empty fuel reading and temp reading are nil. If fuel gauge goes from empty to full can be ground wire problems.
The temp sending unit for the temp gauge is located on the drivers side of the engine between cylinders 3 and 5 spark plugs.