0
Procedures replacing the alternator on a 2000 Ford Expedition 5.4L?
Wiki User
∙ 15y ago
Do yourself a favor. When buying a New Alternator have them check it before taking it home? I had a bad incident that I ended up with, 3 bad alternators in one day, 3 different stores. Last store check it before I took it home and everything was good. I ended up changing it 3 times. Make sure they also change the pulley. Alternator Removal & Installation 1. Disconnect the negative battery cable. 2. Rotate the drive belt tensioner away from the drive belt and remove the drive belt from the alternator pulley. 3. Detach the electrical harness connectors at the alternator assembly. 4. Disconnect the positive battery cable and remove the nut and washer. 5. Remove 2 front alternator bolts. 6. Remove the rear alternator support bracket retaining bolts and the support bracket. 7. Remove the alternator from the vehicle. To install: 8. Place the alternator in position and loosely install 2 front alternator retaining bolts. 9. Install the alternator bracket and 3 alternator bracket bolts. Tighten to 84 inch lbs. (10 Nm) 10. Tighten 2 front alternator retaining bolts to 19 ft. lbs. (26 Nm). 11. Connect 2 electrical hardness connectors to the alternator assembly. 12. Connect the positive battery cable and install the nut and washer. Tighten the nut to 72 inch lbs. (8 Nm). 13. Rotate the drive belt tensioner away from the drive belt and install the drive belt on the alternator pulley. 14. Connect the negative battery cable. 15. Start the engine and check for proper charging system operation.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you remove alternator in a 2000 Ford Expedition?
What causes the generator to burn out after replacing the alternator
Replacing Alternator on 2000 S10 truck rebuilt alternator?
Start replacing the 2000 s10 alternator by disconnecting the battery. Remove the air inlet hose, and the serpentine belt. Take off the bracket over the alternator if it has one. Unbolt the alternator and disconnect the wires. Reverse the procedure to install the new alternator.
Where is the voltage regulator on a 2000 expedition 5.4liter?
The voltage regulator is inside the alternator.
How do you and step by step instructions on replacing an alternator on 2000 Elantra?
Instructions are here:http://www.rdtiburon.com/index.php?showtopic=30576&hl=alternator
Where do you get a dual alternator bracket for a 2000 expedition 5.4 it is not a diesel?
Dc power makes a bracket
What is the cost of replacing an alternator?
I just paid $310 ($254 parts & shop supplies, $56 labor) to have alternator replaced on 2000 Olds Bravada.
Where is the 2000 Crown Victoria voltage regulator?
Inside the alternator. It's part of the alternator. If you are having problems with low or high voltage output, I'd recommend replacing the alternator as a unit.
How do you replace the alternator in a 2000 Chrysler Sebring convertible?
When replacing the alternator on a 2000 Chrysler Sebring convertible begin by removing the belt. Next, remove the wiring. Lastly, remove the retaining bolts. Reverse the process to install the new alternator.
What can cause the battery light to come on in a 2000 Expedition but the voltage gauge reads fine?
Possible bad alternator.
How do you change the starter solenoid in a 2000 Ford Expedition?
will the solenoid in a car cause it to shut off like a bad alternator
What would cause the battery light to stay on after replacing with a new battery in a 2000 Nissan altima?
alternator or bad wires
How much would it cost to replace an alternator in a 2000 Oldsmobile Intrigue?
It is important to know the cost of replacing parts or making repairs on a car. For a 2000 Oldsmobile Intrigue it should cost between $90 and $200 for a person to replace the alternator on their own.
