if it is the caliper at the rear u need the special tool to turn the piston clockwise to push in and counterclockwise to pull out
You will need special brake caliper tool such as a C-clamp to push back the piston on the caliper of a 2002 Mitsubishi Lancer.
They need to be wound back in, using a special tool, a G-clamp also work to push it back, with the rotating part on the caliper piston.
There is a specialty tool for this procedure. There is a metal plate that fits on the piston, then a clamp for the back of the caliper. Turning a screw will pull in the caliper. Opening the bleeder valve may be necessary.
You will need to push the caliper piston back as well as rotated when you are replacing your rear brake pads. The caliper will need to be turned clockwise.
There is a specialty tool for this procedure. There is a metal plate that fits on the piston, then a clamp for the back of the caliper. Turning a screw will pull in the caliper. Opening the bleeder valve may be necessary.
In most cases, no, however if you are having issues getting the piston into the caliper, it may be seized, or it may be a turn in caliper.
the caliper needs a special tool. the piston does not push straight in. the spring needs to be released at the rear of the caliper. then using the special tool the piston twists back in to place
get a large pir of grips and squeeze should go back in.
YesYes
Use a C clamp to push the piston out of the way to remove and also to place back on rotor.
If you are wanting to colaspe the piston so you can fit new pads in the caliper, first open the master cylinder, then use a "c" clamp or "c" clamp vise grips to slowly push the piston back enough to place the pads in and then fit caliper over your rotor.Keep in mind there may be a mess at the master cylinder.
They make a tool to push the calipers in and can be bought at most auto parts stores and some will rent them. Some people use a c-clamp to push them back in.