Old rope type seal. Rase engine drop pan lossing main berring caps, cranck will drop down a bit. Carefully remove seal materal. follow install directions on repacking the seal Rope type seal. if its a newer genII engine remove transmission & flexplate or flywheel from back of crank shalft. u will see the seal, carefully pry it out. Do not scratch the journal it rides on or problems will be a foot. lube new seal were it rids on crank journal tap it in and tourque everything down when putting it back 2gether. Either way it sucks 2b u pain in the but long day job. David G
the crank sensor is located on the back of the engine aprox. 1 inch above the oil pan. there is one bolt holding it in place, after removing the bolt pull the sensor out installation is reverse
NO, my god no
In most engines, yes only if the crank is not damaged and measures correctly.
where is the crank sensor located on a 2005 chevy impala
Simple description: The crank sensor sends information to the ECM so that it knows when to fire the plugs. It is located behind the harmonic balancer. It requires removing the balancer in order to remove and replace it.
Chevy did not use a crank sensor on that year.
trying to locate crank shaft sencor for 1993 Chevy lumna trying to locate crank shaft sencor for 1993 Chevy lumna
a Chevy 350 crank is a Chevy 305 crank. they have the same stroke, 3.48 inches, and are interchangable. swapping between the two cranks does not change the engines displacement
Just the crank. The flywheel is neutral.
No.
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
A crank sensor was not USED on a 1995 model.