0
This is a safety critical system on your car, you need to have the basic back ground knowlege to perform this task. The answer below is geared toward such a person on purpose.
The front calipers are nothing special, remove the bolts.
The rear calipers can be a fight, undo the park brake cable first, the adjuster is under the rear of the car, and the cables get disconected at the caliper park brake arms. There are little tangs that hold the cable into the bracket, I have a small blunt chisel and hamer I release these with. The pistons cant be pried in as the piston must be turned toget it to retract. You may have to sand the lip off the rotor to get the caliper off the rotor. Retained the same as the front with two bolts.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you disengage buzzer for emergency brake 1984 fiero?
Easiest would be to disconnect the wire at the emergency brake handle.
How do you remove a 1984 Pontiac fiero engine?
Drop the cradle & engine together
When was Pontiac Fiero created?
Pontiac Fiero was created in 1984.
Where can i find caliper kits for a 1984 fiero?
Just got mine from NAPA, 12, 2009. Also autozone, Advance, E-bay,...Calipers Rebuilt and Rebuild kits.
How do you replace an universal joint on the right front of a 1984 Chevy full size blazer?
Jack up and support the right front of the vehicle. Remove the wheel/tire. Remove the brake caliper and hang the caliper with a piece of wire out of the way. Remove hub/rotor assembly. Remove backing plate and spindle. Slide out axle assembly. Replace u-joint as you would on a driveshaft. Assemble in reverse order.
Where is the fuel pump for a 1984 4 cylinder fiero?
Unfortunately it is in the gas tank between the seats. To get to it you have to remove the tank working underneath the car, and then remove the pump from the tank.
How do you replace brake pads and rotors on an 1984 Chevrolet Caprice?
Remove the wheel. Use an Allen key to remove the two screws attaching the caliper. I put a long metal bar over the long part of the Allen key for leverage. Lift the caliper off the roter and remove the pads. Use one of the old pads over the caliper piston and a c-clamp to push the caliper piston back into the seat. Be sure to push it all the way in or the caliper will not fit over the rotor once the new pads are installed. I found that the sleves in the caliper where the bolts go also need to be pushed back or they will prevent you from fitting the caliper back on. Then you should be good to go. VBdenny
How to install front brake pads 1984 f150?
remove bolts from caliper and loosen break fluid release valve. remove assembly from rotor. the best way to depress piston is to use a large c-clamp. install new pads, replace assembly, replace brake fluid, bleed the lines, CHECK FLUID LEVEL, done!
What was the first year the Pontiac Fiero was made?
1984
How much horsepower in the 84 fiero?
The listed rating of the 1984 4-cylinder Fiero is : 94hp (if I recall correctly)
1984 Pontiac fiero?
Yep, they built a bunch of those
Will 1987 s-10 engine fit 1984 fiero?
no
