Want this question answered?
there is no drive shaft it's front wheel drive
Remove the front drive shaft
You have to remove the drive shaft and take to to a machine shop. It has to be pressed off Rob
Get the drive shaft out of WHAT? Front wheel drive vehicles are considerably more difficult to remove than most rear wheel drives unbolt it
i think you mean the front drive shaft flange. Unbolt it with a large impact. i think its a 22mm but that's just off the top of my head so don't quote me on that.
Remove 2 small u-bolts from rear end yoke Pry drive shaft out of yoke Slide front end of drive shaft off front splines
You can if you remove the rear drive shaft.
Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.
if leaking out small hole in middle of front driveshaft yoke, check o-ring in cup on output shaft. have to remove extension housing.
its simple its just 4 7/16 bolts on the rear of the shaft and the front just slides out.
you dont, if you want to disconnect it then remove your front drive shaft.
1: disconnect the drive shaft from the rear axle. 2: disconnect the front shaft from the transmission (tedious and you need the correct size tool). 3: disassemble the front shaft from the main shaft by pulling them apart from the center or in front of the support and drop the main shaft. 5: remove bolts holding the support and drop and remove the front shaft shaft with the support still connected. 6: remove and replace the support with a wheel puller. 7: replace support with new part. 8: reassemble in reverse. CDARCO