If the starter bolts are difficult to remove on a 1997 Ford Taurus, they were probably put on using an air wrench. An air wrench can be used to remove them or a product called Liquid Wrench.
Replacing the starter on a 1991 Chevrolet Cavalier can be difficult for someone who has never worked on cars. The car first needs to be jacked up so that the starter can be reached. Then the wires will need to be taken off the starter and labeled so that they can be placed back on the new starter. The start will then then be taken off by removing the bolts. After the bolts are removed, the starter can be taken off and replaced.
Begin by removing the positive cable from your 1998 VW Jetta battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. There will be three starter retaining bolts.
The starter's located directly below the air intake throttle body, on top of the transmission. Removing and reinstalling the starter is not that complicated, the bolts are a little difficult to access, but I did it myself without any real complications. Just be sure to disconnect the battery first.
It's a real pain. I had to bend the head of a wrench to get at one of the 4 bolts holding it in. If you have the engine out, it's real easy. A lot of times the starter is the not the problem on these bikes. The starter bendix that is behind the clutch is the problem if you hear grinding when you try to use the starter.
Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.
The starter on a 92 Buick LeSabre is replaced by disconnecting the battery, removing the retaining bolts, and lowering the starter. The wiring harness can then be disconnected and a new starter installed.
Slide off - after removing mounting bolts
Replacing the starter on a 1999 Monte Carlo is fairly easy to do. The car will need to be jacked up to reach the starter. The wires will need to be disconnected from the starter before removing it. After the wires are removed, the starter can be taken down by removing the two bolts. After the starter is removed, replace it with a new one.
starter located right side under exhaust manifold . remove BATTERY CABLE!!!remove 3 10mm bolts from heat shield one is on rear of shield behind manifold..remove starter bolts one by one move wires from new to old starter .reposition starter install two bolts holding starter on . replace all e heat shield bolts and ground wire.
A person an change the starter on a 2002 GMC Sierra 1500 by disconnecting the battery and removing the retaining bolts on the starter. The original starter is then disconnected from the wiring and a new starter reconnected.
front side of engine just under oil filter. 2 bolts and 2 nuts to get it out
The starter motor on a Citrogen Berlingo can be changed by first removing the electrical wires. Remove the three bolts that hold the starter in place. The starter will come out. Reverse the process to install the new starter.