0
everyone should have a manual for their vehicle, and the library should have a professional shop manual available in the REFERENCE section...make copies of the right sections...good luck :) To reset your change oil light, GM uses the "3-step" method:
I have a 1997 and here is what the manual says to do:
With the ignition key in the RUN position, but the engine off, fully push and release the accelerator pedal three times within five seconds. If the CHANGE OIL SOON light flashes two times, the system is reset. However, if the light comes on and stays on for five seconds, it did not reset. You'll need to reset the system again. ...Good Luck!
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you reset the ABS light on a 1998 Chevy Monte Carlo?
The light is on because there is a problem with the system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself after a short drive.
How do you take out the light rheostat on a 95 Monte Carlo?
How do you take a rheostat out of a 2003 monte carlo
How do you change the third brake light bulb in a 1995 Chevy Monte Carlo Z34?
carefully
How do you reset the check engine light in a 2003 Chevy Monte Carlo?
unhook a battery cable for about 3 minutes and re-hook.
What does it mean when security light comes on 2004 Monte Carlo?
i have a 2004 chevy monte carlo and the service engine soon light is on what does it mean?
How do you reset the change oil soon light on a 96 Monte Carlo?
Try turning ignition key to the on position (don't start) and depress the gas pedal 3 times within 5 seconds.
How do you reset Service Engine Soon light Monte Carlo 1996?
Take it to a mechanic, and have them erase the codes. Auto zone and advance will not do it as they are not mechanics
How do you reset the change engine oil light on a 2000 Monte Carlo?
Turn car on but don't start the engin. Pump breaks a couple times. Turn Key to off then start engin all the way. Light should be off.
How do you replace brake light switch in Chevy Monte Carlo?
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
How do you reset the low coolant light on a 2003 Chevrolet Monte Carlo SS?
You have to have a computer programmer module, from O'Reily's or Autozone to reset it. Some will let you do it and some say that they are not authorized to do it. Good luck...
How do you change the light bulb in the buttons of a 97 Monte Carlo Z34 radio?
Cant Must replace entire radio
How do you reset the oil change light on 2002 Chevy Monte Carlo SS 3.8l?
Turn the key to on (not start) and when the dash lights come on quickly press the gas pedal to the floor three times in less than 5 seconds. This should reset the light. If not, try it again. If you have the drivers information panel you will have to go through the reset on it as described in your owners manual.
