answersLogoWhite

0


Best Answer

You should see no spark if you connect only one cable. You will see a slight spark when you connect the other cable but it should be so minor as to hardly be noticeable. The radio & clock draw power all the time but is in mili-volts. If you see a large spark then something is on drawing power. Connect positive first and negative last.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Should a battery spark if you put the positive terminal before the negative?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Should you disconnect the positive or negative battery terminal first - 45k?

Always the negative cable first.


How do you jump start two 12 batteries?

To jump start an engine via the battery; the remote battery and the host battery, being of the same voltage, should be connected in parallel. That is positive terminal to positive terminal, negative to negative.


Should you reonnect the positive or negative battery terminal first?

Reconnect pos first


The polarity of an eletromagnet is determined by the?

the way in which the positive & negative terminals on the battery or power supply are attached to the electromagnet. switching the leads from the positive terminal to the negative one, and the negative one to the positive terminal should reverse the polarity of your electromagnet.


Where do you put the positive cable to charge the battery i can see the negative it is on the passenger side?

The positive terminal of the battery will be encoded with Red color (either painted or a plastic cover that lifts off) and should also have the marking "+" on it. The negative terminal is encoded with black paint or cover and should have a "-" mark.


During electroplating the item to be plated?

The item to be plated should be attached to the negative terminal of the battery.


How do you replace the battery in a 2004 mini cooper S?

The battery should be in the hatch compartment (behind the rear seats), under the floor mat. Disconnect the negative terminal (black), then the positive terminal (red). Remove the battery, and install the new one in the same position. Reconnect the positive terminal, then the negative terminal. NOTE: The terminals are also designated by plus or minus symbols.


Should you connect the pos or neg terminal first when replacing a car battery?

Assuming the vehicle has a negative earth You connect the positive lead first The reasoning When the positive lead is fitted first, if you dropped a spanner across the battery negative terminal to the car body all you would do is make the circuit. If you connect the Negative lead first, and you dropped a spanner across the positive battery terminal to the car body you would then have a dead short


Should you remove the positive or negative terminal first when replacing a car battery?

Always remove the negative (-) cable first. When connecting it back up connect the negative last.


Why should a car battery's positive terminal be connected first for charging?

Batteries vent Hydrogen gas. You should always connect the positive battery cable first to avoid a spark at the battery that could cause the Hydrogen to explode. The negative cable should never be connected to the battery negative post. It should be connected to another ground area on the engine.


Replace battery 2004 Dodge Durango?

REMOVAL Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off. Loosen the battery negative cable terminal clamp pinch-bolt hex nut. Disconnect the battery negative cable terminal clamp from the battery negative terminal post. If necessary, use a battery terminal puller (2) to remove the terminal clamp from the battery post. Loosen the battery positive cable terminal clamp pinch-bolt hex nut. Disconnect the battery positive cable terminal clamp from the battery positive terminal post. If necessary, use a battery terminal puller (2) to remove the terminal clamp from the battery post. Remove the battery cables from the battery. Remove the battery thermal guard (1). Remove the battery hold down bolt (1) and battery hold down (2) from the battery. WARNING: Wear a suitable pair of rubber gloves (not the household type) when removing a battery by hand. Safety glasses should also be worn. If the battery is cracked or leaking, the electrolyte can burn the skin and eyes. Remove the battery from the battery tray.


How do you remove the battery out of a 1992 lumina?

Start by locating the Positive terminal (usually the red one)... Disconnect it from the battery. Then do the same for the Negative terminal (the black one). Then there may be a small hex head bolt at the bottom the the battery, check for it and remove it, the battery should come right out.