If your fuel pump shut-off switch has been triggered, the Fuel Cutout indicator on your instrument cluster should illuminate. Once the shut-off switch is triggered, you must reset the switch by hand before you can start your vehicle. The fuel pump shut- off is located behind the right rear trim panel in the trunk, you can reach the swith to reset it through the access hole,if you do not see or smellfuel, push the red reset button down, if the button is already set, you may have a different mechanical problem.
It is possible that the switch in one of the doors is stuck in the open possition. It is possible that the switch in one of the doors is stuck in the open possition.
There should be a button on the top right side corner and if you press it it should switch cameras.
The normal position of the inertia switch button is down , if it has popped up then the switch is tripped and no power is going to the electric fuel pump
The button should be DOWN , if the button has popped up on the switch the switch is tripped and no power is going to the electric fuel pump
Pull out type switch? There should be a silver button on the side of the switch (behind dash) Push this button and pull the switch handle Handle should pull completely out of dash Unscrew bezel and switch should drop out from behind the dash Ford suggests replacing connector plug when switch is replaced
The reset button ( which is on the top of the switch ) should be pressed DOWN ( if the button has popped up , the switch is tripped and no power is going to the electric fuel pump )
The button should be DOWN on the fuel pump shut off switch ( inertia switch ) If the button has popped up then no power is going to the electric fuel pump
Normally there will be a button on the monitor. Switch it off and switch it on again - that should fix it.
The button on top of the fuel pump shut off switch ( inertia switch ) should be ( DOWN ) If the button has popped up on the top of the switch then no power is going to the electric fuel pump
There should be a button on the side of switch (behind dash) Depress this button pull on switch knob, entire rod should pull out of switch Unscrew bezel and switch is removed from back Ford suggests replacing wiring harness at the same time
The reset button for the fuel pump inertia switch should be DOWN , if the button has popped up there is no power going to the electric fuel pump and the switch needs to be reset by pushing the button down
There should be a silver button on the side of the switch (behind dash) Depress this button while pulling on stem and entire stem should pull out of switch Unscrew bezel and switch should drop out from behind dash Ford suggests replacing plug also at this time