98? how many miles? and how do you know it is worn out? also to answer your question. "when something breaks, UPGRADE!"
factory or aftermarket? factorys will run you about 120 for a set of 4, aftermarkets are about 450-600.
All i had to do was by the in dash kit and wiring harness and it should plug right in
Pretty much any kind you can afford and install.
In San Francisco the cost is $1100-$2100. Aftermarket to Original. Aftermarket tops cost as little as $300, while the BMW dealer part is well over $1000. The top replacement takes about 8 hours labor for an experienced installer. The window can be replaced on an original BMW top. The replacement window is about $125 from BMW. It takes an experienced installer less than 30 minutes to replace and can be done in under an hour by an inexperienced owner.
radio = head unit same thing, different names
You should consider getting yourself a service manual. Either from your factory manufacturer or aftermarket. Both one should be good as they do teach you how to AC replacement.
NO. But both these barrels are easy to remove and replace and there is a wide selection of factory or aftermarket replacement choices available for both guns.
no you do not. not even if you have the rockford fosgate package. you just wire up the aftermarket harness(95+ nissan) make sure you connect the blue/white wire. that will turn on the factory amp.
If you're smart, you don't. Most aftermarket headlamps give much worse performance than new genuine (factory/original/stock) headlamps.
Factory installed HID headlights are legal in all 50 states. Aftermarket kits the majority of the time are not unless you replace the reflector lens housings with projector lens housings.
A range top replacement is best done by a professional installer.
If you have the Xlt you need a harness adapter that wires to the aftermarket radio harness so that it plugs directly into the factory harness for the aerostar.The reason for this is that it has a factory equalizer that can not be bypassed unless you rip it out and run new speaker wires.Scousch makes an adapter for it, the adapter model numbers are FDK4 or FDK2B.