uneven or non true surface of 1 or all surfaces, wich can cause a bad seal. or a carburetor that you have had rebuilt by 2 separate people but still it is still not working properly ( like my self )
Carburetor jets don't usually get worn, they get clogged. And the signs are hard starting, sputtering, and slow acceleration. A carb rebuild is usually the best solution.
A bad, stuck or dirty float needle inside the carburetor.
bad seal in between your intke manifold and carburetor
signs of bad luck are when sometiing bad happens and it keeps happning for the whole day. those are the signs of bad luck.
Bad timing/valves/rockers/timing chain
How does it run? If it is running rich or lean then the carburetor could be the culprit. If it is original from 1986 I would bet it needs a rebuild.
Bad\dirty carburetor or not getting gas.
carburetor or spark plugs
its fuel injected, no carb on that bad boy
No! There are no bad birth signs.
Numerouse possibiities, bad gas, bad carburetor, bad spark plugs, bad spark plug wires, bad ignition coil, bad battery, bad ignition swithc, etc..
if you definitely have a carburetor,most likely you have a bad purge valve when the diaphragm goes bad it allows the motor to suck raw fuel through the vacuum hoses into the engine