answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-07-09 13:26:09

check the fluid level on the brake system...also check all the fuses...also You should be able to find a shop manual at your local library with the right info...make copies as they are usually only in the REFERENCE section....good luck:)

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


it is the light telling you that your brakes are not performing the best they can. take the car to a service shop and get your brakes done.


How do I reset the differential light on my 2006 Nissan Titan truck? Light came on while driving, and I cannot find out how to reset light.


Yes there are laws regarding texting while driving in many states.



Check all electric system, mainly alternator. Alternator's brush may be worn out.



There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.


It may take a while but yes. Mine has had two go out and I felt it a couple of weeks before the check engine light came on.


The oil pressure could be low. Or the oil sensor could be bad. The vehicle should have a fresh oil change if its anywhere near time, and the oil pressure tested. The sensor is easy to replace if its bad.



Have vehicle scanned to determine the problem



Artificial light is any light that is produced except for stars, our sun,... etc. While Natural Light is light that came from stars, our sun,...etc.



You need to find out what the check engine light came on for. Have the computer scanned for codes. When certain errors occur that could damage the engine, sometimes the computer will just shut down the engine to prevent damage. That may be what happened to you.


The EPC light came on today on a 2001 Seat Ibiza, along with the car's lock suddenly locking. After 3 or 4 efforts, we figured that the problem was solved unlocking the car using the key while the engine was on (the electronics on the car always blocked when the EPC came on). After that the EPC light switched off. I hope you can solve the problem this way.


I have a 2000 venture and the traction control light came on. Where do I look first, hubs. Wiring.


If its totally dead (no radio, no starter) I would first look at your alternator/battery. This happened to my 2003 Trailblazer, and we had to replace the serpentine belt and the alternator. Battery light came on while driving and within ten minutes, the car was dead.


All "check" lights come on briefly when starting your engine. This is to make sure the light is working if soemthing does malfunction on your vehicle. If the light comes on while driving you may have broken or loose belts.


Not enough info. Which ever gauge was out of the safe zone is the system that needs checked.


Get car scanned for codes at most parts stores for free. Could be a CPS crank position sensor or cam position sensor. If crank sensor is bad, will not start. Get codes checked first.



unplug the negative wire from the battery for a few minutes. if this doesnt work it has to be cleard with a scaner(shop)!



Three days ago I was driving an my Coolant warning light came on ... while driving to shop which was less than 2 miles away it blew steam and coolant everywhere - I pulled over and had the car towed to the shop. He informed me that it was a Valve problem and replaced the valve - this morning while driving to work it happened again - with the new valve! He thinks it might be a head gasket. Does this sound right? suggestions?



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.