If there's nothing wrong with the starter itself, there's a 99% chance it's the starter relay (located on the passenger/front side of the engine bay, mounted on the fender behind the battery). It's a square part with a few wires attached. I don't think many auto parts stores can test this to see if it works, but if I recall, it's a pretty inexpensive part (had to replace it on my 87 Grand Marquis). Good luck.
Yes
Toyota previa starter motor wont engage
Yes
if it is a dohc motor it will be four but if its a single over head cam it should be 2
starter motor need overhaul
armature
I remove the starter and test it, then take a pry bar and try to tun the motor over by inserting it into the teeth of the flywheel.
The Bendix on a Ford starter is a one-way gear that engages when the starter is activated. and the Bendix is perhaps one of the most common starter failures.
For a 1995 Ford Crown Victoria : ( 5W-30 engine oil )
It means either you have a bad connection to the starter (dirty cables, wires, etc) or that you have a bad starter motor. The click is actually the starter solenoid kicking the starter drive into position, but the starter motor either is not getting the juice required to turn the engine over or is shorted and not allowing the starter to turn. Either way, the problem is in the starter motor circuit. You're best bet is to clean ALL electrical connections between the battery and starter. If that doesn't work, you probably will need a new starter.
Yes. Both are 4.6 L
thanks how many holding blots and where bad bendix (starter drive) if the spring in the starter bendix is weak or broken it will not engage the flywheel; but the starter will turn normally. bad thing is ,you have to pull the starter..good luck..