do you have a diagram for pontiac grand am 2005 thermostat
At the point where the upper radiator hose clamps to the engine is the thermostat housing. Inside is the thermostat.
To replace the thermostat on a 1997 Pontiac Grand Am 3.1, first disconnect the negative battery terminal and loosen the clamp on the radiator hose. Next, remove the mounting bolts from the thermostat housing and insert the new thermostat.
Is the engine a 3.1? If so it is easist to remove the crossover pipe, then the thermostat housing.
INSIDE A HOUSING ON THE ENGINE END OF THE TOP RADIATOR HOSE.
Follow the upper raditor hose from the raditor to the motor, the raditor hose is connected to the thermostat housing, take the houseing off, the thermostat is under the housing.
Follow the upper radiator hose back to the engine. It should be connected to the thermostat housing. The thermostat is under there.Take Care,Greg
Inside the thermostat housing, follow the upper rad hose back to the engine, under the throttle body.
where can you find a diagram of 1994 pontiac grand am motor?
The thermostat on a 2003 Pontiac Grand Am 2.2L L4 Ecotec is replaced by removing the upper radiator hose and unbolting the thermostat housing. The thermostat can then be removed, a new gasket installed, and the replacement thermostat put in place.
Follow the upper radiator hose from the radiator to the engine. It should be in the metal housing the hose is clamped to.
Under the throttle body on the driver side. Follow the upper hose to the block.