Want this question answered?
What is the tonque specs on the front wheel bearing for an 02 ford F150
a quarter turn before you strip the nut out
ford f150
295 ft-lbs
29-33 ft. lbs.
2000 f150 fron axle nut
225 ft lbs
== 12-16 Foot pounds (Final torque) Note: to torque bolts & nuts, start in center using crisscross pattern working outward The Head Bolt Torque 65-72 Foot pounds (Final torque) Torque sequence ------------ front | 9 5 1 3 7 | of | 10 6 2 4 8 | engine ------------ Final torque must be reached in 3 equal steps Recheck final torque in sequence The Intake Bolt Torque 23-25 Foot pounds (Final torque) Torque bolts & nuts in numbered sequence --------------- | 5 1 9 11 3 7 | | 6 4 12 10 2 8 | --------------- The Main Bearing Cap Torque 60-70 Foot pounds (Final torque) The Main Bearing Cap Torque 60-70 Foot pounds (Final torque) The Rod Bearing Cap Torque 19-24 Foot pounds (Final torque)
depends on the engine size the 4.6 flywheel to crank is 62lbs and pressure plate to flywheel is 18lbs
there is no drain plug on the transmission pan u have to remove the whole pan and there will be a filter inside, u have to replace the filter, pan gasket and make sure to tighten all the bolts to the proper torque specs with a torque wrench hope this helps u
1997 ford f150 fuel pressure specs
You tighten it down until it is snug ( hub will be stiff ) and back it off 1/4 turn. The slots on the castle nut will line up with the hole for the cotter pin. You tighten it down to set the bearings into place, then back it off till it spins freely without play.