Top Answer
User Avatar
Wiki User
Answered 2012-07-10 08:18:32

the relay is in the abs pump

User Avatar

Your Answer

Related Questions

the relay for both pumps is located underneath the passenger glovebox with the fusebox

How do i time rover 75 v6 engine/

Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180 Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180

in my opinion yes, i got my 75 rover a while back and it still works perfectly

There are 7 hurdles in a 75 meter relay

where is the parking buzzer located in the rover 75 .its somewere in the front but i cant find were as it has stoped working

The height of the 2006 Land-Rover Range-Rover is 6 ft. 3 in. (75 in.).

you can find the sump plug in rover spares department.

you have to take to a rover dealer to put out the service light

it realies on the ABS cable front offside to work you will probably find that the cable has rubbed against the wheel and worn the cable through, i assume you have an ABS light on the dash board also Cheers Carl mrcapage" let me know

i have a rover 75, 1.8. it has about 26,000 miles on clock. when does my timing belt need changing

under the rear seat on the drivers side on a v6 75

There are extensive guides on the Rover Owners Club forums. Google it!

I note the relay (part No NCL100040) is called an "ignition and glow plug heater relay". The 75 will usually start if you turn the key before the glow plugs have heated, therefore the glow plugs are probably only needed for cold starts. Glow plugs are not needed when a diesel engine is hot. The "ignition" reference may mean that some other circuit is controlled by this relay (obviously there is no conventional ignition as it is a diesel). FYI The part is also used on the Range Rover TD6 post 2002 An internet search suggest the cam sensor can cause starting problems and fault codes similar to a faulty glow plug relay.

The starter motor is at the rear of the engine.

The absolute value of any negative number -n is equal to the corresponding positive number n. In this instance, abs(-75) = 75.

$75. Trust me i got some.

Difficult to work on and lots of garages wouldn't touch mine which is a Rover 75 V6 auto. I got a garage to carry out repair for about

Rover 75's can be fitted with Subaru alloys. Mabe others too. Would be good to find out.

It is at the front side of engine next to the trainsmission

Bring all keys and FOBs to dealership.

Its in the plenum camber. The most idiotic place on the car.

To bleed the clutch of a Rover 75, first remove the interior panels on the steering column. Second, remove the master cylinder and use a syringe to inject the fluid into the system and repeat 4 times to bleed the clutch.

About $115. Labor $75 and valve $35. It takes about an hour. Most cars.