DOT (3) brake fluid
DOT 3 Brake fluid.
This depends on what type of vehicle that you have. But in most vehicles you would add the brake fluid to the master cylinder. This can be located on the firewall of your vehicle. Do not confuse a clutch master cylinder with the brake.Make sure you add the fluid to the brake cylinder.
Do you mean the clutch master cylinder or transmission fluid? They both will be under the hood, the clutch master cylinder will more than likely be on the drivers side near the dash and will say what type of fluid to put in (dot 3) and will say clutch master cylinder. Just open the plastic cap when the fluid is cool and fill to the fill line. I believe as long as the brake fluid says dot 3 or whatever type you need it's okay to use. As for transmission fluid, do NOT use brake fluid for that, buy regular transmission fluid
consentric clutch type
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
Generally brake fluid.
All clutch slave cylinder require brake fluid. You will need to check and see if it is Dot3 or Dot4. Do NOT mix the two.
dot 3 or dot 4 break fluid
If you look on the cap covering the master cylinder it will list the correct fluid.
If a pressure type brake fluid dispenser is available attach it to the top of the master cylinder. Other wise fill the master cylinder, start with the wheel cylinder that is furthermost from the master, and bleed until fluid comes out clean and free from bubbles. make sure to replenish the the master cylinder as needed. then proceed to the next farther wheel cylinder and repeat with the rest of the wheel cylinders. top off the master cylinder. Test with the engine off then with the engine running before driving.
The corect DOT fluid will be listed on top of the master cylinder fill cap.
it says on the master cylinder cap. it should be Dot 3 brake fluid