0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace 1991 astro van motor mount?
Use a jack with a board on top to support the engine. Loosen the bolts for the motor mount. Raise the engine slightly then take the bolts out and remove the motor mount. Install the new mount, tighten the bolts, then remove the jack.
How do you fix front bumper if it is bending downwards on a Mazda b2300 1996?
Loosen the mounting bolts, there should be four of them then place a jack under the bumper and jack the bumper up until straight or even then tighten the bolts.
What are b16's and b17's bolts used by boilermakers?
B16 and B17 bolts are specially designed bolts used by boilermakers. These bolts are used in high temperature service areas of the boiler.
How To Change Tires?
To change a tire you will need a jack to lift the car, a spare tire, and a tool to remove the bolts of the tire. Use the jack first to lift the car, then remove the tire, replace it with the new one, and tighten the bolts.
Do I need special bolts or screws for a used awning?
You do not need special bolts. Standard bolts and screws, as long as they are the correct size, can be used.
What size bolts are used to make helicopters?
Many sizes of bolts are used in any helicopter.
How do you remove oil pan from 1985 Ford Ranger?
lift engine by removung the motor mount bolts. jack up engine and remove oil pan bolts
How do you accsess the top bolts on a 1998 s-10 blazer transmission?
You need to put a floor jack under the transmission pan, Then remove the 2 bolts that are in the rear trans mount. Then jack the trans. up till the bolts clear the crossmember, now remove the crossmember out of the way, Then let the jack down real slow being carefull not to crush the distributor against the fire wall. let the transmission come down until you can get a long extention and socket onto the two top bolts. That's how you get them out.
How many bolts used in a car?
It varies from car to car. Suffice to say there are hundreds if not thousands of bolts used.
What eye bolts are used for?
Eye bolts are commonly used to attach cables to objects for lifting or holding in place
Saturn sl1 where's the upper motor mount located How do you replace it?
The upper engine mount is on the passenger side of the vehicle right in the middle of the engine. There are 5 bolts holding it on. The bolts are a size 15mm deep socket. Remove the two bolts on either side. Jack up the engine from the bottom, underneath the oil pan, using a piece of wood between the jack and pan. Now remove the 3 bolts holding the mount to the engine. Replace the mount. Screw 3 bolts back in. Lower the engine and screw the two side bolts back in.
How do you replace a 2001 Hyundai Santa Fe sway bar bushing?
You cannot get at the bolts so you have to lower the sub frame. 4 bolts need to come out on the sub frame with boards and a jack to lower the frame just enough to get at the sway bar bolts. Not too bad after that 4 bolts holding two brackets on the sway bar come out replace bushings(made of Rubber) some have grooves in them which is good to know before you buy them. replace bolts jack the sub frame back up and replace the 4 bolts you took out, Good to go
