Most likely the filter. i would check the fingers inside the filter for tears.
at ur local pool store!
To maintain a small Intex pool you will need a filter, pool vacuum, pool test kit, net, and chemicals. Keep the filter running to clean the water, test the water daily. Adjust chemicals for chlorine, and PH. Use the net to scoop out leaves and debris as needed, vacuum the pool as needed as well.
Change your filter
A small sand filter 40-60 sq ft. and a small pump 3/4 HP
Setting the filter to backwash cleans the filter, running your pump to filter cleans the water in the pool. Brushing the walls of your pool cleans the walls of your pool... and so on.
You don't . You chlorinate the pool with chlorine . You filter the water with a sand filter.
There is no diference. There are different types of pool filters, but it has more to do with how they filter then their application or location.
Yes, the solar pool cover does not effect the filter.
Typically you would tee into the plumbing after the pump and filter with a small hose and a valve that runs to the plumbing on the slide.
The cleaning schedules varies from filter to filter, but a general guideline on any swimming pool filter is to take a reading when the filter is clean, then clean the pool filter when the pressure rises about 10 psi.
Clean it out and start again. Check and manual for the amount of DE in the filter. Too much is like throwing money literally down the drain. While your cleaning the grids check for tears.
Plugged pump, very dirty filter. Do you actually mean the filter or the pump. Filter is big tank. Pump is small unit with motor attached.
From the pool
A pool skimmer is generally built into the side of or around the top of a swimming pool in order to skim debris from the surface of the water. A pool filter is built into the plumbing in order to filter fine debris from the water itself.
The sand filter wont make a pool green this happens a s a result of algae.
Salt is not a filter, it is added to pool water to allow a chlorine generator to operate.
i have a intex pool 12x 30 uses filter size A how long should i run the filter for
I assume you have a sand filter if so you most likely have broken laterals in your filter. A lateral should allow water through but not sand. if you have a DE filter and you are getting what appears like sand in the pool, you have one or more of the filter grids that have holes and the DE is passing through the filter grids back to the pool.
NO POWER CORDS IN THEW POOL ! I KNOW ITS HARD TO KEEP THESE CLEAN SO THE BEST WAY IS TO FIND A INGROUND PUMP AND FILTER SAY A 1 HP STA RITE DURA GLAS AND A 50 SQ FOOT CARTRIDGE TYPE FILTER. WHEN THE POOL GOES BAD YOU WILL BE ABLE TO RESELL THE PUMP AND FILTER AND GET YOUR MONEY BACK..
That's quite possible. A filter, or filter change should do the trick.
form_title=Pool Filter form_header=Pool service professionals are available to help you with all of your pool filtration needs. Are you having problems with the filtration system of your pool?*= () Yes () No Do you need a pool filter installed?*= () Yes () No Is your pool above ground or in ground?*= () Above ground () In ground Is your pool a chlorine or salt water pool?*= () Chlorine () Salt water
Because dirt and small sand will pass through the filter the first time it is run after backwashing. By rinsing you are sending that debris, which could cloud your pool, out of the backwash port instead of back into the pool.
The filter has nothing to do with the rust stains. You can remove small rust stains from a plaster surface with a small amount of diluted muratic acid. There is a tool specifically for this task which will make it easier to get the acid to the stain. The tool can be found in some pool supply stores. Ken
You don't have to change the pool filter for years Unless it gets damaged. You do however have to clean the pool filter whenever the presure leading to the filter gets too high. This indicates a dirty filter that is not allowing water to get through effectively.