Want this question answered?
Tire Rack has an online site that walks you through all the sizes including OEM.
150/80x16 front, 170/80x15 rear.
4x6 in the dash, 6 1/2 in the door, 4x10 in the back.
The 1993 Dodge Intrepid had two OEM tire sizes. The factory fitments for this vehicle were the P205/70/15 and P225/60/16 sizes.
There is a table of Astro Tire Sizes at http://astrosafari.proboards.com
It depends on the OEM engine that came in this Mustang. If it came with a 200 inline 6 cylinder or 289 V8 then Ford installed 2 different sizes on this vehicle.185/75-14195/75-14If however is came with the 289 High Output or 428 then the OEM size is:205/75-14If it had the 390 as the OEM engine then it came with one of these 2 sizes:195/75-14205/75-14
Check the owners manuel for the exact location. If you can't find it, try the driver side door.
The 1991 Mazda 323 came equipped in two OEM tire sizes. Assuming the vehicle still has the original wheels the sizes were 155-13 and 175/70/13.
Of course you can, but it will effect handling, braking, performance, and fuel mileage, plus your speedometer will no longer be accurate. My advice is to stick with the OEM size tire. Saying that you can change sizes if you choose a tire that has the same overall diameter as the OEM tire. For instance if you OEM size is 235/70-16 you can install a 215/75-16 which would have almost the same overall diameter as OEM.
If the ticking is coming from the top of the engine it is likely the Hydraulic (valve) Lash Adjusters.A fresh oil change using a quality oil and ***an OEM filter from the dealership*** should clear the noise up within 15 minutes of driving.Use of a non-OEM filter can cause valve train ticking noise.
Cummins (OEM) 12 valve (single wire) oil pressure sensor is located below the injection pump and could be in front of or behind injection pump support bracket. The location was determined by the factory installing the engine. Cummins (OEM) 24 valve (three wire) oil pressure sensor is located below the ECM.
The difference between an OEM controller and a non OEM controller is that an OEM controller is made by Microsoft. A non OEM controller is made by other companies. OEM stands for Original Equipment Manufacture.