American Cars
Chevy Trucks and SUVs
Ford F-150
Chevy 350

What are the cylinder numbers on a 1997 Dodge Intrepid V6 3.5 24 Valve?

Top Answer
User Avatar
Wiki User
Answered 2006-07-20 05:21:07

Many engines do not have the cylinder numbers cast on the block or the head. The only way to tell is to buy the maintenance manual for the car, and to look up the 'engine' section. Under 'Timing' it will tell you the firing order, the layout of the cylinders, and how to install the timing belt/chain.

User Avatar

Your Answer


Still have questions?

Related Questions

Where is the egr valve on a 1997 Dodge Intrepid 3.5 liter?

It's on the passenger side cylinder head in the back.

Where can i find the Egr valve on a 2001 Dodge Intrepid 3.5 liter?

where can I find the egr valve on a 2001 dodge intrepid 3.5 liter

If a 1999 Dodge Intrepid timing chain goes out how likely is it a valve in the heads can be damaged?

If a 1999 Dodge Intrepid timing chain goes out a valve in the head can easily be damaged.

Where is the proportioning valve on 98 Dodge Intrepid?

There are four proportioning valves. They are located by all four tires within the brake line. It is a small cylinder shaped valve about two inches long.

Where is the valve body on a 2002 Dodge Intrepid?

Inside the trans pan.

Where is the range sensor on a Dodge Intrepid?

It is inside the trans, on the valve body.

How tight does the bolts on a 94 Dodge Intrepid valve cover have to be?

The bolts on a 94 Dodge Intrepid valve cover need to be very tight. You should tighten to 12 N*m or 105 inch pounds.

How do you get solenoid pack out of 2004 dodge intrepid?

You have to remove the pan and valve body.

Where is the Solenoid Switch Valve located in a 2004 Dodge Intrepid transmission?

It is inside the valve body inside the transmission.

Where is the PCV valve located on a 1995 dodge avenger 2.0 4-cylinder?

On the valve cover

How do you siphon fuel from dodge intrepid?

You can't, there is an anti siphon valve in the filler neck.

What causes valve covers on dodge intrepid to crack?

The bolts that hold it on are over torqued.

97 intrepid 3.5L FIT IN A 99 DODGE INTREPID?

Yes they will , just change around the valve covers and intake from the new to the old.

Where are the spark pluGs located on a 1999 Dodge Intrepid?

Under the coils on top of the valve covers

Where do you find the transmission solenoid for a 2002 Dodge Intrepid?

It is inside the trans, on top of the valve body.

96 Dodge Intrepid keeps over heating?

Did you bleed the air valve? if you open any part of the cooling system on a dodge intrepid, ie: change the radiator hose or thermostat housing. You need to bleed the air out the Valve. If not the car will over heat.

How do you you replace a valve cover gasket on a 1995 Dodge Intrepid?

Begin by removing the valve cover from your 1995 Dodge. Remove the valve cover gasket and clean the surface. Put the new gasket on and return the valve cover to its original position.

How can you tell if the ac air compressor on a 99 Dodge Intrepid is shot?

Bad bearing Bad valve

How do you replace the PCV valve on a 2000 Dodge Intrepid?

On the 2.8 it's on top of the plenum at the back. disconnect the hose & unscrew the pcv valve & replace.

Where is neutral safety switch for 96 Dodge Intrepid?

Inside the transmission, on top of the valve body. Dodge calls it a trs ( trans range sensor)

Where is the idle air control valve on a 2002 Dodge Intrepid?

The 2002 Dodge idle air control valve is located on the outside of the air cleaner housing. The idle air control valve can be found on the left-hand side of the housing.

How do you find the PCV valve on a 1997 Dodge Intrepid?

it's in the intake plenium, in the rear center. Its black plastic and has a hose attached to it that goes into the valve cover.

Where is the Egr valve on a dodge 4.7?

rear of the drivers side cylinder head

Cold engine noise for 2004 Dodge Intrepid?

Valve clatter? Check oil level and pressure? Fuel mixture?

Where is the camshaft sensor on a 1997 Dodge Intrepid 3.5L?

drivers side in the timing cover just before the valve cover.