Want this question answered?
I believe the correct answer is 2 bolts
I believe the caliper is held by 14 mm bolts.
You will need to remove the door panel of your 1995 Toyota. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
Inbetween the seats(top and bottom) you have to hold them apart you'll see some bolts you have to take out.
It's 17mm bolts on that year Camry.
to install a water pump on a Toyota tercel 1.5.
It's inside the distributor cap. Remove distributor cap, remove two 8mm nuts and four small Phillips head bolts. Slide coil up out of distributor.
on the right side of the engine, behind the water pump, above the transmission is your starter simply remove the nut with a 12mm socket or wrench unplug the plug attached to it, and remove the 2 bolts with a 14mm socket and replace the starter. I just replaced a started on a 94 today. The easiest way to get the bolts out is too remove the air filter and the housing it sits in. under the filter is 3 12mm bolts. remove those and the screw that connects the filter to the intake. Once that is out of the way you can get to the bolts from the top of the car pretty easily.
The front bumper bolts directly to the factory mounts on the frame. You need to remove four bolts, two on each side. Use a 14 mm socket wrench. The bolts are parallel to the ground and perpendicular to the center of the vehicle.
Yes but don't know the number of wrench
If the starter bolts are difficult to remove on a 1997 Ford Taurus, they were probably put on using an air wrench. An air wrench can be used to remove them or a product called Liquid Wrench.
a wrench