Piston 1&4 have to be at TDC, T- mark on the generator side has to match with the upper and lower block joint. Intake camshaft goes on the carburetor side and exhaust on the manifold side. Camshaft caps are named I1,I2 and E1, E2 they have an arrow which should point to the clutch side. E2and I2 goes on the clutch side and i1,E1 on the generator side. !1and e1 have a punch mark which is aligned with thepunch mark at the camshafts 90 degrees vertical from the block where they sit. Install exhaust camshaft with out any slack and the install intake cam, you might need to rotate this second shaft to get it aligned. install chain cover and torque all bolts to 7.2 ft/lbs install tensioner on the side and get a new gasket for the cover. Good luck.
location timing marks 1993 dodge datona
timing marks 1993 yoyota Camry 2200
The timing marks on a 1993 Geo Metro are located on the on the camshaft and crankshaft sprockets. They must be aligned together to ensure proper initial timing.
i need to know where the timing marks should be on a 93 sporster .
The timing marks can be found on the front main pulley and the flywheel. The timing marks indicate when a certain piston is at the top of its stroke.
timing marks dodge 2.2 engine how to set them
Check
why did my timing belt break on my pontiac 1.6 1993 motor also will the valves be bent because of that
Diagram of ignition timimg marks
MY TIMING MARKS ARE UNDERNEATH INSTEAD OF THE USUAL TOP LOCATIONS FOR PICKUPS
tdc 12 degrees
May be computer controlled and not adjustable