0
What are the torque specifications for 89 s-10 rocker arm stud?
Wiki User
∙ 9y ago
For the 1989 Chevy S-10 with the 2.5 liter engine, the torque setting for the rocker arm bolt is 22 ft. lbs. The torque setting for the rocker arm cover is 75-inch lbs.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What the Rocker arm torque specifications on a 1990 4.3 liter s-10 4x4?
The rocker arm torque specifications, for your 1990 4.3 liter Chevrolet engine, is 15 pounds per square inch. The rocker arm should be torqued in five pound intervals.
Rocker arm torque specs for 1997 Pontiac Transport 3400?
The 1997 Pontiac Transport 3400 rocker arm torque specifications are 18 pounds. The rocker arm should be torqued in six pound intervals.
What are the rocker arm torque specifications for a 455 cubic inch Oldsmobile engine?
According to most Oldmobile torque specs, the correct torque for rocker arm bolts is 25 ft-lbs.
Rocker arm specifications for a 1994 3400 sfi?
what are the torque specs on a 3.4 s.f.i
What are the torque specs for the rocker arms on a ford f-150 with a 4.9 liter engine?
Rocker arm stud nut or bolt 17 to 23 foot lbs
How can i get rocker arm stud bolt back in the head on a 4.9 liter ford 6 cylinder?
rocker arm stud is pulling out. how can i get it back in
What is the torque on rocker arms for a C15 CAT?
The torque specifications fourth the rocker arms, on your C 15 Caterpillar diesel engine, is 14 pounds per square inch. The rocker arm should be torqued at seven pound intervals.
How can a rocker arm on a 1990 Geo Tracker be replaced?
By removing the valve cover from the engine, then removing the rocker nut on the bad rocker. Refer to a technical manual for torque specifications, as this must be properly torqued!!!
What is the torque sequence for rocker arm bolts on a 1991 ford 1.9 engine?
There is no torque sequence just torque rocker arm studs to the proper torque
Why does Rocker arm cut into stud?
You have to much lift on the camshaft lobe, They make a long slot rocker arm that looks like a stock rocker arm but it will not cut into the stud. The slot is where the rocker arm fits over the stud. If you are not haveing coil bind problems with the valve springs are broken springs then you can keep the cam that's in it and just use the long slot rocker arms are roller rockers to fix you problem.
How do you know the size of the rocker arm stud on your car?
Remove a rocker cover and measure one.
Rocker arm torque specs?
what is torque spec for rocker arms on 2004 4.6 landrover discovery
