You will need a NEW set of 10 new head bolts ($40-45). They are supposed to be STRETCH bolts, and are therefore NOT to be reused. There is a bolt pattern. Torque three times at 58 foot pounds of torque. 20/22R/RE head bolts are not torque-to-yield (stretch), and are re-usable! Torque is 55-63 foot pounds. Thoroughly clean the bolts on a wire wheel and inspect for pitting, especially in the threads and replace as necessary. It is also recommended to re-torque them after about 1,000 miles. following the torque pattern, one at a time, loosen the bolt the least amount possible, and then turn to torque spec - 55-63, although many of us who do this regularly go to 70. Oh - and don't forget the "11th head bolt" buried in the pool of oil below the distributor gear, but it should only be torqued to about 14 foot pounds.
36 ft lbs and then 90 degrees
58 ft lb inner to outer clockwise staging...
torque for 2c engine cylinder head bolts
The torque specs for a Toyota Camry cylinder head is 60 pounds for the inside bolts and 50 pounds for the site bolts. The cylinder head bolts should be tight from and to end alternating.
1991 toyota camry head bolts torque specs
What is headcylinder bolts torque on toyota 2c turbo
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
33 ft lbs and then 90 degrees then another 90 degrees in an x pattern
Step 1 - 20 NmStep 2 - 78 NmStep 3 - 90oStep 4 - 90o
The 2005 Yamaha cylinder bolt torque specifications are 90 pounds per square inch. The cylinder bolts should be torqued at 30 pound intervals.
torque specifications
The cylinder head on a Toyota Paseo requires 33 pounds of torque on the head bolts. If the bolts are over tighten the block can warp leading to a blown head gasket.