Be very careful when removing or tightening the head screws. There is a certain order and method for loosing and tightening the screws in order to avoid warping the head. When loosening them, you only turn each screw 1/4 of a turn at a time. Likewise, when tightening them, you will tighten each screw three times. However, you should do them in the recommended order. You should purchase a Chilton's repair manual. It does a good job of walking you through the entire process.
Torque specs
The piston rod torque specs for a 2002 Honda accord 4 cylinder are 151 ft lbs
what is the torque on front wheel bearings for 1998 honda accord
The valve cover torque specs for a 1989 Honda Accord is between 20 and 25 pounds per square inch. Proper torque is important to keep the cover in place without causing damage or leaks.
97 honda accord headbolt specs
They need to be torqued to 22 lb.ft and then turn them 180 degrees in 2 steps start from the center and work out. Read more: 1998 honda accord 2.3L head bolt torque specs - JustAnswer http://www.justanswer.com/honda/1k1jk-1998-honda-accord-2-3l-head-bolt-torque-specs.html#ixzz1pntfWIDI
According to the 1994-1997 Honda Accord Service Manual the torque specs are: 74 N.m (7.5 kgf.m. 54 Ibf.ft)
head torque specs for 2002 honda rancher
34 ft-lbs according to haynes manual.
80 foot pounds. Almost all Honda vehicles are 80 foot pounds.
22ft pounds first torque followed by 49 ft pounds final torque an d recheck in proper order
first torque them in sequence to 29 ft lbs, then to 51 ft lbs, then to 72 ft lbs.