Bolt pattern and torque specs are here:
http://Toyota.offroadforum.cz/aarc.epnet.com/application/8578/8578R03_Cylinder_Head.html
In SI, torque is measured in newton metres (N.m). The percentage torque varies according to the design and specifications of a motor.
There is usually a plate on the crank-case or transmission housing.
What is the sump bolt torque on a Toyota Town-ace van 2y 1800 motor
what is the torque specs to a 2002 Chevrolet Malibu 3.1 liter motor. Need head and intake torque specs. and sequence.
you can't crank it shut, the motor is electronically worked by a switch. You will probably need to replace the switch or the moonroof motor is no longer good.
Torque specifications are different from motor to motor. These specifications state how tightly the head bots are to be installed. Correct torque insure that the head gasket is sealed properly and correct torque sequence insures that the head itself is not warped in the installation process. Refer to a engine repair manual (Chilton's, Hayne's, etc.) for your vehicle/motor for the correct specs and torqueing sequence. You can usuall find these manuals at your local auto parts store. Hope this helps.
rod bearing Toyota tercel 87
DC Motor Specifications: 1.RPM 2.No-heap Speed 3.Slow down Torque 4.Most extreme Current
No don't believe it would have enough torque to crank motor fast enough to start
The motor specifications of the Razor E200 Electric Scooter are as followed; 24V (two 12V) sealed lead acid rechargeable battery system with battery charger included, speeds up to 12 mph with high torque chain driven motor.
1996 chevy c1500 pick up 305 motor bolt torque spec intake manifold
This Is To General Question. It Could Be The Torque From The End Of A Ratchet To The Torque From An Electric Motor Shaft, Or From The End Of An Engine Crankshaft. This term is often used coloquially to indicate the power available from a car battery, i.e. how long will the starter "crank" before the battery goes dead.