If you don't have the original bolts to see what size they are then
you will have to just look at the bolt holes and see the size.
Use a bolt and try screwing it into the hole.It should fit snuggly and no
play side to side.Length will have to be trial and error.They should go all
the way into the hole with at least 8 full turns.And they must clamp up tight.
Use only grade 8 bolts.
The motor mount bolt size for a 1996 Windstar 3.8 is cross-thread a 3/8" bolt. That is the only bolts that will fit.
3/8-16
What size bolt for a 2005 Honda civic DX power steering tank bracket..
it is the same size of the bolt same as the hole and thread. the higher the grade of the bolt the more touque you can apply.
yes!it.s the same size but do it with the same transmission
7/16 coarse i believe
a two inch one
3/8-16x1 1/4 Grade 8
if it's the same transmission it will bolt right up.
1 1/4 / 7/16-14
It's usually 3/8-16 for the bell housing and 7/16-14 for the tailshaft mount.
In most cases the Toyota Corolla motor mount bolt is a three-quarter inch by four inch long bolt. To be absolutely sure of the size of motor mount bolt you will need to know the year of your Toyota. +++ I don't know what the bolt screws into, or if it has a nut on it, but be aware that it may be metric (19mm dia X 100mm long being very close to 3/4" dia X 4" long) but not necessarily from the standard M-series or complementary metric fine-thread range. If it is a metric fastening the A/F size of the head will be in mm too, of course.